Part Number: TLV314 Tool/software: Hi,
I am using this circuit below to measure motor current by amplifying the differential output by 11. But even without motor i am getting a sinewave in the output as attached. This wave is there when i power the circuit…
Part Number: TLV314 Tool/software: HI, I am looking for the Matlab Simulink / Simscape model for TLV314 to use in one of my simulation to prove the concept to use the IC further. I can find only TINA and PSpice models in the product page. can you please…
Hi Kevin,
It's been several weeks since we heard back. I'm going to assume that this issue has been resolved and close the thread.
Best Regards,
Robert Clifton
Part Number: TLV314-Q1 Other Parts Discussed in Thread: TLV314 Hello,
To read the current of each phase in motor drive application, shown in figure 1 (Ia, Ib, Ic), an offset voltage of 1.65V is created using TLV314.This is due to the fact that the current…
Part Number: OPA335 Other Parts Discussed in Thread: TLV314 , Hi,
I'm using the circuit below to sense the DC BUS voltage, ADC_Udc=(135/23919)*Udc, ADC_Udc is fed to the ADC of MCU.
The DC bus voltage ranges from 50V to 500V.
I compare the actual DC…
Part Number: TLV314 Other Parts Discussed in Thread: TINA-TI Hi,
I have one MFB circuit built using TLV314.
I am assuming that spice model of TLV314 doesn't include offset voltage.
In case of steady state, input will be attenuated by Rf/Rin which…
Part Number: TLV314-Q1 Hi team,
As one of reliability information, it seems the customer would like to know what the behavior of TLV314-Q1 is when adjacent pin is shorted. Do you have any documents, materials or blogs that shows the behavior at short of…
Hi Russell,
I'm assuming you are looking for the TLV313-Q1 Pin FMEA. We do not have the documentation for the TLV313-Q1 Pin FMEA online but the Pin FMEA for the TLV313-Q1 will be identical to the TLV314-Q1 as long as the pin outs of the packages you are…
Part Number: LM258 Other Parts Discussed in Thread: TLV314 Hi team,
Below is LM258 SCH. We can see, if it work, LM258 U1 is output 0.5V. But actually it output 0.53V. When remove R492, it output=0.5V normally.
Keeping R392 in the board, I let U2 , U3…
