Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TLV4111 Other Parts Discussed in Thread: OPA521 Hello Texas Instruments team,
Please, when using TLV4111 as a volage follower, can i connect the Vdd pin to the input pin of the op amp ?
I have this question because this component is only…
Part Number: TLV4111 Hello,
I want to build a spice model of a circuit i'm working on but decided to start with a simple model to ensure that the TLV4111 was working correctly. For some reason the output of the op amp in the configuration below…
Part Number: TLV4111 Other Parts Discussed in Thread: OPA388 , OPA320 , LM8272 , LM8261 , LM8262 , LM7321
Hello,
I'm working on a design to "digitize" an old analog vehicle sensor and running into some issues that I believe are tied to trying to drive…
Part Number: OPA569 Other Parts Discussed in Thread: OPA548 , , TLV4110 , TLV4111 , OPA2677 Hi Team,
Our customer is looking for a voltage follower with current sink capability of 150mA that will be driven by a single 5V supply voltage, has an input voltage…
Hi Larry,
I did what you suggested with a single Resistor at the output (no LED), TLV4111/TLV4113 op amp should not oscillate. It will handle 10kHz input switching signal.
/cfs-file/__key/communityserver-discussions-components-files/14/TLV4111-E2E-02032021…
Hi Larry,
I posted the 3:48 am response about the TLV2772 simulation after you asked the question about limiting the TLV4111 input to + 4.5 V. The reason I posted that particular response about using the TLV2772 op amp is you had mentioned that the circuit had…
Part Number: TLV4113 Other Parts Discussed in Thread: TINA-TI , TLV4111 Tool/software: TINA-TI or Spice Models I downloaded the TINA TI Spice model for this part from:
http://www.ti.com/product/TLV4113/toolssoftware
When running the model in feedback loop…
Other Parts Discussed in Thread: TLV4110 , TLV4112 , TLV4111 Hi,
My requirement is that I need to accept a signal between 1-100 KHz, and supply it on 6 output ports. In short, I am looking for a 1-to-6, or at least 1-to-2 analog output drive buffer. Can…
Other Parts Discussed in Thread: OPA547 , TLV4111 , XTR110
Thanks for your reply. As u suggested me before, Two possible op amps might be the TLV4111 and the OPA547. But what i feel is that, these two op-amps output current range is little high.
Dear…
Manjunath,
Two possible op amps might be the TLV4111 and the OPA547. Best selection would depend on the desired characteristics of your circuit. TI's web site has an op amp section category for high current op amps and this may be of assistance to find…
