Part Number: TLV9152 Hi,
When simulating an unity gain buffer with the TLV9152 in PSpice, I see significant differences in the output voltage swing compared to the data sheet. It defines a headroom of typically 200mV at 2k load and +-8V supply.
But in…
Part Number: TLV9154 Hi, in the latest (rev.D) datasheet of TLV915x there is some inconsistency in regards to EMIRR - there are two plots of EMIRR vs frequency and they differ significantly. One is Fig. 6-41 and the other Fig. 7-1. There are differences…
Part Number: TLV9152 Hello Guys,
Good day.
Our customer just like to clarify the following.
The shutdown pin for the component TLV9152SIRUGR is not clearly described in the data sheet. On page 7 it says that Low (V-) switches the amplifier on and High…
Part Number: TLV9152 Other Parts Discussed in Thread: LM7705 I am using this part as 15 gain amplifier for sensing the current through a load.
Based on an analog 0-10V input, the microcontroller outputs a PWM duty cycle to the LED load; the current is…
Hello Carolina,
Thanks for your suggestion. I have a question. TLV9102 and TLV9152's absolute max of supply voltage is 0 ~ 20V. Is is OK to input over 20V if the input current is limited to less than 10mA? Regards, Oba
Part Number: OPA2374 Other Parts Discussed in Thread: TLV9062 , MCP6292 , TSV912 , TLV9152 , OPA2323 When testing this series of op-amp in an integrator circuit we discovered some significant coupling between the input and the output feedback. This phenomenon…
Hi Dane,
To add to Clemens list, I think the TLV9151, TLV9152, TLV9161, and TLV9162 would also be good fits, depending on what supply voltage you are needing.
Best Regards,
Robert Clifton
The absolute maximum ratings forbid voltages above V DD .
Use opamps with a shutdown pin (e.g., 2× TLV9152), or insert an analog switch (e.g., TMUX6219).