Part Number: TS12A4515 Tool/software: Dear TI technical support,
I used TS12A4545 analog switch for my current design. I am using four of these switchesTS12A4514 and TS12A4515 to switch from one sensor to another. I am using one pair of these switches…
Part Number: TS12A4515 Other Parts Discussed in Thread: TMUX136 what is the phase noise degradation going through the part? What is the PSRR? Planning on using it to switch a 10 MHz signal with phase noise -175 dBc/Hz @1 kHz. Need to understand what will…
Part Number: TS12A4515 Hello. I was wondering if the IN pin buffer shown in the block diagram is Schmitt triggered or not. If not, is there a maximum tolerable rise time requirement?
Thanks
Narek
Part Number: TS12A4515 Hello
My question is regarding the supply current of the analog switch TS12A4515(package doesnt matter). In the datasheet, 0.05 µA can be read for 3V supply. But on the TI page of the product, the supply current is listed as…
Part Number: TS12A4514 Other Parts Discussed in Thread: TS12A4515
Hi teams,
Good day!
My customer use the TS12A4514/ TS12A4515 , and there is confusion about the IN pin logic voltage.
Regarding the "Electrical Characteristics for 12-V Supply …
Yaita-san
What do you think about the TS12A4515? This device can pass signals up to Vcc which can be 12 V. The only thing I'm not sure about how you would reference the IC since the TS12A4515 device cannot pass negative voltages.
Let me know what…
Other Parts Discussed in Thread: SN74CB3Q3306A , SN74CB3Q3305 , TS12A4515 , TS12A4514 Hi,
Can you please confirm if INPUT of SN74CB3Q3305 or SN74CB3Q3306A is high Z when,
1) Vcc=0V
2) Vcc=3.3V but OE/=high (disabled)
I see only max Vcc level difference…
Satoshi-san,
I see the difference now. Thank you for clarifying.
The TS12A4514 and TS12A4515 device are bi directional solid state FETs switch and don't have any moving parts like a mechanical switch. It doesn't matter if the COM signal is the input…
Narasimha,
No, you may not operate the TS12A4515 the way you describe because it violates the recommended operating conditions in the datasheet.
If you operate the device with V+ = 5V you many not place a signal on the COM,NC, or NO pin >V…
