Part Number: AM2434 Dear Champs,
Is it possible to overlay boot-loader SW by application SW code section?
If so, could you please share some example cmd file and idea how it can be implemented?
Thanks and Best Regards,
SI.
Part Number: MSP430FR6005 Other Parts Discussed in Thread: MSP430FR5043 , EVM430-FR6047 Hi
Our company develops systems for water managing and for early detection of leaks.
We are testing the possibility of using a component from the MSP430FRXXX series…
Part Number: SW-EK-TM4C123GXL Other Parts Discussed in Thread: TM4C123GH6PM Tool/software: Code Composer Studio Hello,
I have started to write stand alone ASM programs but I am getting two errors: I am using the Tiva C launchpad.
CORTEX_M4_0: File Loader…
Hi charles
I tried to build the project boot_demo_emac_flash, with uart prints , Iam getting the following outputs in terminal
PFB image
PFB code please suggest what change need to be done get the IP address or tell the procedure how to test this demo…
Hey Hong,
Apologies for not responding to this thread earlier. We discussed these details during our weekly sync meeting. To recap:
1) SW PORz Reset (SW_MCU_RESETz) (Equivalent to MCU_RESETz pin): This reset isn't supported in your use case since the…
Other than all the DCSM security values being right shifted 1 byte (obviously from factory defaults). OTP checksum failures do not cause issues until FAPI programed flash bank1 sector 12. The ROM boot loader passes his OTP checksum via INTOSC2 10MHz PLL…
First you will need the MSP430 FRAM BSL guide . Refer to section 3.3.2 Hardware BSL Invocation on how to place the MSP430 into BSL mode. You do this using the RST and TEST pins on this device.
Next, I believe your device has a UART boot loader so you can…
4.f) How to flash the IBL (Intermediate Boot loader) into EEPROM and how to flash the application binary into NOR? How to boot the IBL + Application.
https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1073147/faq-tms320c6678-how…
Hi,
Velliyangiri palanisamy said: In the below forum discussion please find the answer for the question why "--embedded constants" need to make it OFF .
https://e2e.ti.com/support/microcontrollers/arm-based-microcontrollers-group/arm-based-microcontrollers…
Hi Yousuke-san,
I think TI team has tried as much as possible to answer various repeating questions from you and your colleagues. In this below post, I have answered about the difference between a ROM-based bootloader and a Flash-based bootloader. When…