Part Number: AM62X-PET-CALC Hi TI
In the power estimation tool, how to selec the mode column list as below?what's the represent meaning of every item?when i used this port as GPIO which one can i select?
BR JINGCHENG
Part Number: TMS320C6678 Hi TI
This DSP has been replaced with DDR3 particles, and its delay parameters have changed. We have used the "DDR3 Register Calc v4" calculation tool to regenerate the configuration parameters, and then downloaded the program…
Part Number: ADS124S08-EXCEL-CALC-TOOL Other Parts Discussed in Thread: ADS124S06 Dear Sir / Madam,
If ADS124S06 is selected on the Register Map sheet, AINCOM cannot be selected with MUXP or MUXN.
Why?
Thanks and best regards,
Hi Hajo,
Hajo Krabbenhöft said: From what I understand, the TLV320ADC3101 uses a delta-sigma modulator with 128-times oversampling, which comes out at 6.144MHz raw sample clock for a final 48kHz digital signal.
This is correct. You can input a PWM signal…
Hi Liang
For audio, LC filter mostly check the frequency response results. You could follow below link to use the tool to check the results. And from experience, usually around 1uF is a good choice.
https://www.ti.com/tool/LCFILTER-CALC-TOOL
Hi Mani,
Optionally as well, At the output you can implement an LC filter with a cutoff frequency of 20kHz to attenuate switching and cut high frequency noise. You can use this calculator to determine component values ( https://www.ti.com/tool/LCFILTER…
Hi David:
List is get 1080P monitor edid but use calc tool will fail.
Please tell me how to modify it , thank you
[0000]
0
FF
FF
FF
FF
FF
FF
0
4
72
F3
3
A1
C3
20
3
[0010]
20
1E
1
3
80
30
1B
78
EE
34
55
A7
55
52
A0
27
[0020]
11
50
54
B3
0C
0
7…
Hello Beatrice, Have you tested both outputs, first channel is a ferrite bead filter and 2nd channel has a 4.7uH and 0.68uF L-C Filter. There's going to be rolloff once you hit the the edge of the audio band so this is expected to a certain extent.…
Part Number: LM5141DESIGN-CALC Other Parts Discussed in Thread: LM5141 The design tools I believe maybe incorrect. According to the latest rev.D datasheet page 16 equation 4 is states:
However in the Design Tool provided Rfb1 and Rfb2 are swapped. Shown…