Hi Hamid,
I think the greatest advantage of inline current sensing should be the simplicity to implement. Please refer to section 2.2.1.1 in the attached document for the suggestion on current sensing with low-side sensors.
/cfs-file/__key/communityserver…
Hello Conor,
Q1: 512 mS retry delay in case of thermal shut down. 540mS is retry delay during CB mode.
Q2: There is not recommended value. It usually depends on the end application. To reduce the risk of negative spike due to parasitic inductance min…
Part Number: CC1110-CC1111 Other Parts Discussed in Thread: SIMPLICITI I'm familiar with the IAR Kickstart versions having a code size limit, but I seem to be over the 0x1000 limit just building the peer to peer sample app to use with the RFUSB eval board…
Hello Brian,
So for the TDA4VL (J721S2) we have a singular PMIC solution, you can find the guide for that here Powering Jacinto TM J7 SoC Family For Isolated Power Groups With TPS6594133A-Q1 PMIC and Dual HCPS Converters
We recommend PDN-3X for newer builds…
Allison,
For simplicity, I created a simple program on LP1 with SCIC (transmit only) and SCIB (receive only) on LP2 but they are not working.
I enabled the SCIC TX FIFO interrupt (see below) and have disabled everything related to RX FIFO interrupt since…
Part Number: SK-AM62B-P1 Tool/software: Hi Team,
I am trying to run multiple tasks at a time on m4f.
For simplicity, now I have taken two tasks,
Task1 - Continously print hello world.
Task2 - Continously read ADC output.
Please find the file in the…
Fizix,
The intended profile would be more of a circle on the center of the array of vary diameters. Looking at the drawing, it shows window frame, seal, etc.. While, the way they are attached is important, I was mainly trying to determine the larger components…
Part Number: DRV104 Other Parts Discussed in Thread: DRV8935 , DRV8955 , DRV8904-Q1 , DRV8912-Q1 Tool/software: Designing a ramp-up/Ramp-down PWM driver circuit for proportional valve. DRV104 is close to what is needed in this design, but would like to…
Hi Tom,
To use UART2, you will need to configure the device pinmux for the UART2 peripheral.
For simplicity, I am going to demonstrate this using the Empty SDK example, but this can be configured in any CCS project.
After importing the CCS project into…
Part Number: LM74704-Q1 Other Parts Discussed in Thread: LM74800-Q1 Tool/software: Hi,
I am looking for a solution to protect my circuit from a load dump (ISO 16750-2 4.6.4 Test B) in a 24V system. It should either limit/clamp the voltage to max 48V…