Frequent Questions

  • [FAQ] Interface Transceivers: E2E Homepage

    Welcome to the Interface Transceivers E2E page! Here you will find a variety of resources that support our long list of devices (750+ and counting!) Select an interface below to find a collection of FAQs, application notes, videos, and more: …

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to GPIO

    Part Number: AM625 Other Parts Discussed in Thread: AM62L , AM62P , AM62D-Q1 , AM62A3 , AM6422 , AM623 , SN74LVC1G08 , AM2431 , , AUDIO-AM62D-EVM , AM62A7 , SK-AM62P-LP , AM62P-Q1 , SYSCONFIG , AM5728 , SN74LVC1G17 , AM2432 , DRA829J , AM62A7-Q1 , AM6442…

  • [FAQ] DS320PR810: How should PCIe signals be AC coupled?

    Part Number: DS320PR810 Other Parts Discussed in Thread: DS320PR1601 , DS160PR1601 Tool/software: How do I check to make sure my PCIe signals are AC-coupled correctly?

  • [FAQ]: My simulation in ICS is very slow - how do I fix it?

    FAQ: TPLD > Current FAQ The two biggest causes of slow simulation are: Fast oscillators and switching signals Large simulation timescales (simulations that take 1+ seconds) If the simulation is utilizing a square wave with a period that is…

  • [FAQ] Are TPLDs pin-to-pin compatible with competitor devices?

    FAQ: TPLD > Current FAQ Numerous TPLD products are either pin to pin or layout compatible with competing products. Our products utilize standard, JEDEC packaging standards.

  • [FAQ] Can my TPLD be changed after programming?

    FAQ: TPLD > Current FAQ Once a TPLD is permanently programmed or “burned” through OTP, the design cannot be changed. If you wish to change your design after permanently programming an OTP part, a new, previously unprogrammed part must be used.

  • [FAQ] How is TPLD programmed?

    FAQ: TPLD > Current FAQ TPLD is programmed through SPI communication enabled by the programmer firmware and InterConnect Studio (ICS). Each TPLD device uses 5 pins to program the device: 4 pins for SPI communication and 1 pin (GPI) that provides a specific…

  • [FAQ] What do I use to program TPLD?

    Other Parts Discussed in Thread: TPLD1201 FAQ: TPLD > Current FAQ TPLD is programmed through our software tool, InterConnect Studio (ICS) , in combination with a TPLD programmer and EVM. TPLD programmers and EVMs can be found on the “Hardware development…

  • [FAQ] Can I permanently program TPLD in-system or in production myself?

    FAQ: TPLD > Current FAQ No, current devices do not support in-system or inline programming (support is planned for future devices). For large scale production, we recommend you have TI program the devices before shipping. Customers can program devices…

  • [FAQ] Can a third party program TPLD for me?

    FAQ: TPLD > Current FAQ Yes. Currently TI has enabled Dediprog to work as a third party for programming TPLD.

View FAQ threads
Recommended For You