Frequent Questions

  • [FAQ] DRV8714-Q1: DRV8705/06/14/18-Q1 False VDS over current flag debug

    Part Number: DRV8714-Q1 Other Parts Discussed in Thread: DRV8718-Q1 Tool/software: Gate driver (e.g DRV8714-Q1) has VDS over current protection. One of common debug work of gate driver is false VDS over current fault. Even if motor current is not high…

  • [FAQ] What is PassFET Hang Time?

    Other Parts Discussed in Thread: TCA39306 FAQ: Logic and Voltage Translation > IxC >> What is PassFET Hangtime? To understand what passFET hangtime is, we need to define what a passFET is. A passFET is a transistor where the drain and source terminals…

  • [FAQ] TCAN1057A-Q1: why is the CAN Mosfet and Diode used

    Part Number: TCAN1057A-Q1 Tool/software: Hello experts！ I have a question about the purpose of the Mosfet and diode in CAN interface？ Further，How does CAN implement arbitration and error correction functions through hardware?

  • [FAQ] BQ25770: Schematic Review

    Part Number: BQ25770 Other Parts Discussed in Thread: TIGER Tool/software: Hi Team, Would you help me to review this BQ25770REER Schematic for customer? Thanks! Best Regards, Thomas Luo

  • [FAQ] AM6421: Functional and Performance Verification of AM64x + LPDDR4

    Part Number: AM6421 Tool/software: hello: I am seeking a comprehensive and effective strategy to accurately evaluate and confirm the functional integrity and performance capabilities of the LPDDR4 memory modules. Whether there are references or…

  • [FAQ] AM62A7-Q1: Maximum ripple voltage allowed on the power rails

    Part Number: AM62A7-Q1 Tool/software: Hi, We are going to do AC power simulation on the AM62A-Q1 chip, We need the fail criteria for this simulation, or in simple words what is the maximum voltage ripple allowed on each power rails of the chip…

  • [FAQ] PROCESSOR-SDK-AM62X: How to Toggle GPIOs and LEDs from U-Boot Command Prompt

    Part Number: PROCESSOR-SDK-AM62X Tool/software: I want to toggle a GPIO or toggle a LED from the U-Boot Prompt. How can I do this?

  • [FAQ] TDA4VH-Q1: Enabling QUAD Ethernet Communication on TDA4VH TI EVM

    Part Number: TDA4VH-Q1 Other Parts Discussed in Thread: TDA4VH Tool/software: Enabling QUAD Ethernet Communication on TDA4VH TI EVM

  • [FAQ] PSPICE-FOR-TI: Adding a Library to PSPICE

    Part Number: PSPICE-FOR-TI Tool/software: Importing a library file and creating an OLB file for use in PSPICE-FOR-TI

  • [FAQ] DP83822HF: How does power up sequence affect PHY operation?

    Part Number: DP83822HF Tool/software: For DP83822, there is a guidance where AVD and VDDIO must not exceed 0.3V prior to complete supply ramp, with an additional footnote suggesting AVD to ramp up after VDDIO to avoid false detection of VDDIO. False detection…

View FAQ threads
Recommended For You