Frequent Questions

  • [FAQ] TPS650330-Q1: How can I get design documents for TPS65033xx-Q1 devices?

    Part Number: TPS650330-Q1 The design documents (datasheets and TRM) are on TI MySecure folder. Customers can request access from the link below: www.ti.com/.../swlicexportcontrol.tsp Once approved, design documents can be accessed from the link…

  • [FAQ] AM3352: Number of assigned MAC addresses

    Part Number: AM3352 Hi, I read on the forums ( https://e2e.ti.com/support/processors-group/processors/f/processors-forum/166910/am335x-efuse-mac-ids-always-valid/609758#609758 ) that any AM335x device has either 2 or 3 MAC addresses programmed to…

  • [FAQ] What are the benefits of Opto-emulators vs. Optocouplers?

    FAQ: Isolation >> Opto-Emulators >> Current FAQ What are the benefits of Opto-emulators vs. Optocouplers?

  • [FAQ] DRV8245S-Q1LEVM: How to fix the DRV8245S-Q1LEVM not connecting to GUI and nFAULT not working?

    Part Number: DRV8245S-Q1LEVM Our team recently discovered an issue with the recently released DRV8245S-Q1LEVM. The EVM fails to connect to the GUI, and the nFAULT LED doesn't display the status of the nFAULT signal on the microcontroller. This is due…

  • [FAQ] PSPICE-FOR-TI: How do I get PSpice for TI?

    Part Number: PSPICE-FOR-TI How do I get PSpice for TI?

  • [FAQ] AM69: How can I assign interface ID to CAN modules

    Part Number: AM69 I want to use the CAN interfaces can0, can1, can2 and can3 from Linux user space and hence want hardcode the IDs. Currently based on the probe sequence from the Kernel, these get assigned randomly. I tried using aliases in the Kernel…

  • [FAQ] DP83867E: What is the default mode of RGMII when using DP83867, shift or align?

    Part Number: DP83867E When bootstrapped to be in RGMII mode, DP83867 will be in shift mode by default; not align mode. The modes will be corroborated via Reg 0x32[1:0].

  • [FAQ] DP83869HM: How to generate 125MHz on CLKOUT pin for DP83869

    Part Number: DP83869HM DP83869HM needs an additional register to be written to enable CLKOUT modification. By default, this signal is a buffered version of the XI signal. Reg 0xC6 must have 0x10 written in order for the value in Reg 0x170[12:8] to take…

  • [FAQ] BQ4050: FAQ Home Page

    Part Number: BQ4050 FAQs How to enter UNSEAL or FULL ACCESS modes after sealing the gauge? How long does the voltage on the PACK pin need to be applied to wake-up the gauge? What are the differences between hardware and firmware protections? …

  • [FAQ] ADS7066: Integrated features to aid Functional Safety Analysis

    Part Number: ADS7066 Hello, see the integrated features of the ADS7066 that can aid in the functional safety analysis of a system: . ADS7066 Consolidated.pptx

View FAQ threads
Recommended For You