Frequent Questions

  • [FAQ] TDA4VM: How to check device type (GP/HS-FS/HS-SE) ?

    Part Number: TDA4VM Tool/software: How to check device type (GP/HS-FS/HS-SE) ?

  • [FAQ] AWRL1432BOOST-BSD: Sideband Data Capture with DCA1000 for BSD Demo

    Part Number: AWRL1432BOOST-BSD Tool/software: Due to the BSD's demo large number of chirps and adc samples there have been issues with raw data capture with the DCA1000. To help alleviate this issue there are two steps to be taken 1) One cannot start…

  • [FAQ] LMH1297: Manually Adjusting Cable EQ

    Part Number: LMH1297 Tool/software: Hi, When performing diagnostic evaluations of the LMH1297 retimer customers often want to adjust input cable EQ from the IO side. In these cases we recommend disabling the EQ adaptation and performing the following…

  • [FAQ] CAN Transceiver Resources

    [Click here to return to Transceiver Homepage] Welcome to the CAN Transceivers E2E page! Listed below are a variety of resources to assist with the implementation of the Controller Area Network, aka CAN! Frequently Asked Questions (FAQs):…

  • [FAQ] Interface Transceivers: E2E Homepage

    Welcome to the Interface Transceivers E2E page! Here you will find a variety of resources that support our long list of devices (750+ and counting!) Select an interface below to find a collection of FAQs, application notes, videos, and more: …

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to GPIO

    Part Number: AM625 Other Parts Discussed in Thread: AM62L , AM62P , AM62D-Q1 , AM62A3 , AM6422 , AM623 , SN74LVC1G08 , AM2431 , , AUDIO-AM62D-EVM , AM62A7 , SK-AM62P-LP , AM62P-Q1 , SYSCONFIG , AM5728 , SN74LVC1G17 , AM2432 , DRA829J , AM62A7-Q1 , AM6442…

  • [FAQ] DS320PR810: How should PCIe signals be AC coupled?

    Part Number: DS320PR810 Other Parts Discussed in Thread: DS320PR1601 , DS160PR1601 Tool/software: How do I check to make sure my PCIe signals are AC-coupled correctly?

  • [FAQ]: My simulation in ICS is very slow - how do I fix it?

    FAQ: TPLD > Current FAQ The two biggest causes of slow simulation are: Fast oscillators and switching signals Large simulation timescales (simulations that take 1+ seconds) If the simulation is utilizing a square wave with a period that is…

  • [FAQ] Are TPLDs pin-to-pin compatible with competitor devices?

    FAQ: TPLD > Current FAQ Numerous TPLD products are either pin to pin or layout compatible with competing products. Our products utilize standard, JEDEC packaging standards.

  • [FAQ] Can my TPLD be changed after programming?

    FAQ: TPLD > Current FAQ Once a TPLD is permanently programmed or “burned” through OTP, the design cannot be changed. If you wish to change your design after permanently programming an OTP part, a new, previously unprogrammed part must be used.

View FAQ threads
Recommended For You