• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Answers 2 answers
  • Subscribers 47 subscribers
  • Views 343 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BOOSTXL-3PHGANINV: 2MTR-DYNO connections and motor parameters

user805897
Prodigy 210 points
Part Number: BOOSTXL-3PHGANINV
Other Parts Discussed in Thread: 2MTR-DYNO

I purchased 2MTR-DYNO but I don't know the wire color and connector arrangement.
Q1: Is it correct that U = red, V = white, W = black, and GND = green?
Q2: There are two 5-pin sockets labeled J4 and J10 respectively. Which one should be plugged into the QEP? Also, does the "^" mark on the label indicate No. 1?
Q3. we don't know what the 5-pin socket left in the QEP is used for, so please tell me.

  • 0
    Prodigy 210 points

    I would also like to know the notarized inductance and DC resistance of the motor.

  • 0 in reply to user805897
    TI__Mastermind 28830 points

    Hi,

    This booster pack uses sensorless motor control. Here are the answers to your questions with this in mind:

    Q1 – Yes, red white and black are the three phase wires that you want to use and connect to the 3-position screw terminal on the booster pack. The order in which the wires are arranged doesn't matter, ie, RWB, RBW, BRW…, any one is fine. The Green wire is not needed and you can leave it floating.

    Q2, 3 – The rest of the signals for encoding are not used by this booster pack, and you can leave them floating. They're needed for sensored algorithms. If you're using this type of control, please refer to corresponding user's guide.

    The motor's phase to phase inductance is 0.4mH, and resistance is 0.72Ohm according to manufacturer’s datasheet.

    Regards, Guang

  • 0 in reply to Guang Zhou
    Prodigy 210 points

    Thank you for your response.
    I do not want to do a sensorless drive.
    Hence the UVW order and encoder will be mandatory.
    I would like to know if the output of the encoder is labeled "J4" or "J10".

  • 0 in reply to user805897
    TI__Mastermind 28830 points

    Hi,

    For the motor’s signal pin out, please refer to manufacturer’s datasheet here. You can find the relevant info on page 3.

    If you need to use the cables, you can identify by inspection. I suspect the color code matches the motor's, but please verify. I don’t have a hardware set with me, and wasn’t able to find a schematic for the cable unfortunately.

    Regards, Guang

  • +1 in reply to Guang Zhou
    Prodigy 210 points

    Thank you for your answer. I have tried to find the data sheet many times but could not locate it easily. Thank you for your help.