• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 48 subscribers
  • Views 285 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

INA241A-Q1: INA241-A1-Q1

Adam Handzlik
Prodigy 10 points
Part Number: INA241A-Q1

Hello,

my application is a typical bidirectional case with  reference at 2V. 

Unfortunately the part INA241-A1-Q1 happens to have gain of 4 and adding common mode voltage (electrical bus voltage of 28V) changes output voltage dramatically.

See the test arrangement below.

Canask for some advice?

Best

Adam

  • 0
    TI__Mastermind 27720 points

    Hello Adam,

    There should not be a big change from low VCM to high VCM.  I would remove R216 and R217 a drop to a lower resistance as this could cause some errors but not much with regard to VCM changes.  Also please make sure that the inputs are not floating when comparing to the 28V.  The reason is the inputs require the current to bias the inputs and if floating this will not yield accurate results.  


    Regards,
    Javier