• State
  • Locked Locked
  • Replies 5 replies
  • Subscribers 48 subscribers
  • Views 1193 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

OPA2670 Tina spice model

Lokesh E14
Prodigy 140 points
Other Parts Discussed in Thread: OPA2670, OPA2673, THS6212, THS3202, THS3201

Hi,

Can anyone please provide the OPA2670 Tina spice model. It will be very helpful for simulation.

Thanks and Regards,

Lokesh E

  • 0
    TI__Genius 12631 points
    Hello Lokesh,
    Unfortunately we do not have a model for the OPA2670. Can you please let us know more about the application and we may be able to provide more information and assist you with your design.
    -Samir
  • 0 in reply to Samir Cherian
    Prodigy 140 points

    Hi Samir,

    We searching for high speed  Op amp or Line driver for XDSL Application with below requirement for one of our project. Can you please suggest the suitable line driver with below requirement it will helpful.

    Requirement:-

    1. Flat Bandwidth of 100MHz at the Gain of 7.
    2. Supply Voltage +/-12 Min.
    3. Slew Rate of 9000V/us.
    4. Applicable for XDSL Application.
    5. Output Signal Power of 20dBm.
    6. Load Impedance 100 Ohm.
    7. Operating Temperature:-40 to 85C
    8. Tina Spice model.

    Regards,

    Lokesh E

  • 0 in reply to Lokesh E14
    TI__Genius 12631 points
    Lokesh,
    We don't have any amplifier that works at 24V supplies (+/-12V) and has a slew rate as high as you mentioned. Are you sure you need this combination? When I see your output power of 20dBm, that is only around 6Vpp which wouldn't requires 24V supplies, especially since the line driver outputs are differential. Check out the OPA2673 and the THS6212. These may meet your needs.
    -Samir
  • 0 in reply to Samir Cherian
    Prodigy 140 points

    Hi Samir,

    Yes, you are right. We won't require 24V(+/-12V) supply. I have selected THS3202 IC as line driver as well as Receiver. Please find the attached Tina simulation schematic. Can you please help in simulating for Full duplex operation.I have used Ideal Transformer. Is hybrid Transformer is same as Hybrid transformer? Please help us to understand the Full duplex operation.

    Regards,

    Lokesh E

    THS3202_3202_full duplex.TSC

  • 0 in reply to Lokesh E14
    TI__Genius 12631 points

    Hello Lokesh,

    The THS3201 and THS3202 are not recommended for new designs. There are certain production issues so we are recommending people to not use it in any new designs going forward. I think the OPA2673 should be sufficient for your application based on your earlier descriptions.

    With regards to the hybrid I am not an expert on the subject. Here is an old application note I found from TI on the subject of hybrid circuits.

    -Samir