xtr111

Juzer Ekhlas

Other Parts Discussed in Thread: XTR111, TLV4113, TLV2473, TLC083, TLC073

I wish to make a PCB using Altium Designer.I am unable to find xtr111 in any of its libraries.Where can i find the library? Any ideas as to how i can create a PCB on Altium with xtr111.

over 13 years ago

0 Juzer Ekhlas over 13 years ago

Prodigy 30 points

Are there any other chips which are compatible in size and number of pins? i can use their foot print instead to make the PCB layout

0 Collin Wells over 13 years ago in reply to Juzer Ekhlas

TI__Guru 62625 points

Hello Juzer,

If you do not want to create your own footprint using Altium's built-in footprint creation wizard inside of the PCB libraries, then you can try to find another device that shares the same "MSOP-10 + POWERPAD" (DGQ) footprint. Some other product offerings from the Precision Analog team in the "MSOP-10+ POWERPAD" (DGQ) package include:

TLV4113
TLV2473
TLC083
TLC073

Hopefully Altium will have the footprints available for one of those models.

Regards,
Collin Wells
Precision Analog
Linear Applications

0 Juzer Ekhlas over 13 years ago in reply to Collin Wells

Prodigy 30 points

Thanks Colin. I noticed the XTR111AIDRCT being used on the XTR111EVM and hence chose to order those samples but i dont understand the difference or on what basis do i choose between DRC & DGQ .

Does TI provide the gerber files for the XTR111EVM?

0 Collin Wells over 13 years ago in reply to Juzer Ekhlas

TI__Guru 62625 points

Hi Juzer,

The XTR111 comes in two different packages to give customers a choice between a no-lead package (DRC) and a leaded package (DGQ). The DRC package is smaller (3mm x 3mm) due to the fact that it is a lead-less package and therefore will save some board space in the final application. The DGQ package is slightly larger (3mm x 5mm) but is easier to handle and assemble with because of the leads.

I will try to locate the GERBER files for the XTR111 EVM and post them on this thread.

Regards,
Collin Wells
Linear Applications

0 franmoya over 12 years ago

Prodigy 10 points

Hi Juzer,

you can make the footprint with the Altium Designer IPC Footprint Wizard introducing the mechanical data manually.

I already made it for the XTR111, I can send it to you if you want.

Best Regards,

Francisco Moya

0 son nguyenhuu over 11 years ago in reply to franmoya

Prodigy 10 points

Hi Francisco Moya !

I really want to have the footprint with the altium designer of XTR111 , could you give me ? my email address : nguyenhuuson1989@gmail.com

thanks you so much , hope as soon as you can .

Regards !

Son!

Amplifiers

Amplifiers forum

xtr111