LM2901AV-Q1: Altitude related issues

Stefano Scremin

Part Number: LM2901AV-Q1

Dear All,
I need information.

Can you tell me if LM2901AVQDRQ1 could have altitude related problems?
Does the component continue to work well at 6500 m?

In general, what are the altitude related issues for an electronic component?

Thanks in advance for your gently reply.

Best Regards

over 3 years ago

0 Michael Steffes over 3 years ago

Guru 47485 points

Don't forget to consider low temp operation perhaps.

0 Stefano Scremin over 3 years ago in reply to Michael Steffes

Intellectual 430 points

Hi Michael,

thank you very much for your reply.

Yes, the temperature I had already considered.

Instead, I was wondering if there are problems due to less pressure or more rarefied air?

Regards

Stefano

0 Paul Grohe over 3 years ago in reply to Stefano Scremin

TI__Mastermind 49906 points

Hello Stefano,

The packages are molded epoxy, that should not contain any air pockets. The die is sealed within the epoxy. So there should not be any pressure differential to cause stresses across the package.

As Michael mentioned, temperature is a factor. The thermal resistance of the surrounding air increases with altitude, so Theta JA changes.

See the appnote Semiconductor and IC Package Thermal Metrics (Rev. C)

http://www.ti.com/lit/an/spra953c/spra953c.pdf

Particularly section 1.1 and 1.5

0 Michael Steffes over 3 years ago in reply to Paul Grohe

Guru 47485 points

Yea, I was working on the Facebook high altitude drone project at one time (non-confidential) on the laser alignment circuits - the detector and 1st stage op amps were outside the craft - they mentioned in passing one day they would need to be doing some -80C testing - we all fell out of our chairs, nothing is specified that cold.

0 Stefano Scremin over 3 years ago in reply to Michael Steffes

Intellectual 430 points

Hi Paul and Michael,

I will study the information you have given me and if I have other doubts I will contact you again (for this reason I would like to wait a couple of working days before closing the issue).

Thak you very much for your support.

Kind regards and happy week-end.

Stefano

0 Chuck Sins over 3 years ago in reply to Stefano Scremin

TI__Mastermind 23395 points

No problem Stefano

we will leave this open and await your response.

Chuck

0 Chuck Sins over 3 years ago in reply to Chuck Sins

TI__Mastermind 23395 points

There has not been any new input on this post in a while, so it will be closed.

If you have additional questions, please feel free to reply or open a new post.

thanks

Chuck

Amplifiers

Amplifiers forum

LM2901AV-Q1: Altitude related issues