Hello Leo,

The Multi-Cal-System Basic Starter kit or evaluation experimenter module allows you to calibrate 8 sensor cards on the system.  This starter/experimenter kit is intended to aid to start your own PGA309 sensor hardware/software development.  The Multi-Cal-System may be expanded to calibrate additional sensors by using additional Multi-Cal-Slave PCBs. The Multi-Cal-Slave is an accessory board that is used to add 8 additional channels to the Multi-Cal-System. Up to 7 Multi-Cal-Slaves boards may be used with the Multi-Cal-System for a maximum of 64 channels.  

If you are having PGA309 communication issues or questions on the Multi-Cal system:

• Please post the complete schematic of the PGA309 sensor card.
• Please also let us know if this is a voltage out 4-wire, voltage out 3-wire or current output sensor configuration; and provide a diagram of the connections between the PGA309 inteface board and your PGA309 sensor card.
• Please also provide the Pre-Cal File, and Model file you are using in this case.
  Please also provide a snap shot of the PGA309 GUI interface when the issue occurs.

Below is the related documentation to the PGA309, and PGA309 Multi-Cal system that you will find useful.

Thank you and Regards,

Luis

PGA309 Device Information:

PGA309 User’s Guide

PGA309 datasheet

PGA309 MULTI-CAL_SYSTEM Information:

MULTI-CAL-SYSTEM Basic Starter Kit Product Page

Multi-Cal-PGA309 System User’s Guide

Multi-Cal-System Evaluation Module User's Guide (Rev. B)

Additional PGA309 Multi-Cal system boards User’s Guides:

Multi-Cal Masters User’s Guide: SBOU089

USB DAQ Platform User's Guide: SBOU056

Multi-Cal-Cable User's Guide: SBOU092

Multi-Cal-Interface User's Guide: SBOU093

Multi-CAL-SLAVE kit information:

MULTI-CAL-SLAVEKIT Multi-Cal-Slave Circuit Board

Multi-Cal-Slave Evaluation Module User's Guide: SBOU094