This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

  • TI Thinks Resolved

INA283-Q1: VSENSE to VOUT Step Response

Expert 2845 points

Replies: 1

Views: 389

Part Number: INA283-Q1

Hi All,

Spec sheet P10 Figure 21. to 26. shows Common-Mode Step Response.
I need VSENSE =<Differential (V+IN) – (V–IN)> to VOUT Step Response.

Same as Common?

If not, let me know about VSENSE Resonse time.

  • Hello Doi-san,

    The plots that you are looking for are Figures 27 to 30 on P11. These are output referred plots, which means that these are the responses on the output for any gain and VSENSE step combination that would produce the specified voltage on the output.

    Best Regards,

    Mitch M, TI Sensing Products Applications Support

    Getting Started with Current Sensing Video Training Series

    Hall Effect Sensor Video Training Series

    TI makes no warranties and assumes no liability for applications assistance or customer product design. You are fully responsible for all design decisions and engineering with regard to your products, including decisions relating to application of TI products. By providing technical information, TI does not intend to offer or provide engineering services or advice concerning your designs. All information in this correspondence and in any related correspondence is provided "as is"  and is subject to TI's Important notice and disclaimer.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.