LMX2492: Wait time after chip reset?

hien ho

Part Number: LMX2492
Other Parts Discussed in Thread: LMX2491

Is there a specific timing for LMX2492 after SWRST is set? How long should we wait until reset is done? After this do we need to proceed with clearing the SWRST bit? and then proceed with programming registers in descending order?

No where in the LMX2491/LMX2492 document it mention this basic procedure?

over 2 years ago

0 Noel Fung over 2 years ago

TI__Guru* 86200 points

Hi Hien,

The reset will be taken place immediately.

After a reset, you need to program all the register in descending order. As such, you will have a chance to program R2 with the reset bit = 0.

0 hien ho over 2 years ago in reply to Noel Fung

Prodigy 10 points

Hi Noel,

So I want to be clear as a normal initialization procedures should be as follow:

line 1: write (0x2, 4); //where write is define as (register, data)

//no waiting?

line 2: write (0x2, 1);

//no wait ?

line 3: write (0x64,0)

line 4: write (0x63,0)

......

line x: write(0x3,0)

is this correct? or we need to move line 2 (write #2 - clearing the swrst) to the end?

0 Noel Fung over 2 years ago in reply to hien ho

TI__Guru* 86200 points

Hi Hien,

here is a recommended programming sequence:

1. Vcc power up

2. write R2 = 0x205 (SWRST = 1)

3. Program R39, R38, ...., R3, R2, R1, R0 (if you just want to setup the PLL but want to program the RAMP registers later, otherwise start the programming sequence from R141

Clock & timing

Clock & timing forum

LMX2492: Wait time after chip reset?