Other Parts Discussed in Thread: LMK00804B
Hello,
Below is the requirement for our design.
We have a 25MHz crystal oscillator (+/-2ppm) in our design which operates on 3.3V with 0.2V/ns slew rate. We need to generate two clock signals (25MHz) at 1.8V for FPGA and Ethernet PHY.
We are plannig to use LMK00804B for converting 3.3V clock signal to 1.8V clock and feed both FPGA and ETHERNET PHY. Our concern is on the output jitter from the device, as there is no information on the datasheet at 25MHz for the output additive jitter. Can you suggest if this part can be used for the above mentioned application.
Regards
Sudheer