• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 20 subscribers
  • Views 159 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

EYE Mask for DS110DF410

Chitharanjan M1
Intellectual 360 points
Other Parts Discussed in Thread: DS110DF410

Hi team,

Could you please share the EYE mask specification for the DS110DF410 re-timer IC?

Regards,

Chitharanjan M

  • 0
    TI__Genius 13582 points

    Hi Chitharanjan,

    We do not have a strict eye mask for the signal on the receiver side of the retimer, but there is an input jitter tolerance specification provided in the datasheet.

    In past experience, we have observed good BER with at least 0.4UI HEO and 200mVpp VEO. If using the on-chip eye monitor for these measurements, please note that these measurements are taken after the CTLE/DFE retimer stages.

    Thank you,

    Evan