• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Subscribers 20 subscribers
  • Views 219 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMK04616: 8mA HDSD

Shlomi Is'hakov
Intellectual 270 points
Part Number: LMK04616
Other Parts Discussed in Thread: DAC38RF83

Hi

 

How can I connect an HSDS 4mA or 8mA (out clk from LMK04616) to DAC38RF83 that can receive ecl\lvpecl ?

Can I connect them with AC couple only or I need resistor termination?

At the data sheet of DAC38rf83 I have an example of only of ecl and pecl. I need to connect the LMK04616 to those inputs as DACCLK and SYSREF

 

 

  • 0
    TI__Genius 16845 points

    I assumed you were looking at figure 69 of DAC38RF83. It appears that DAC38RF83 has an internal 100 ohm termination resistor. In this case, you can AC-couple LMK04616 output.

    Based on the Vcom specification in the datasheet, a resistor bias might also be required to set the common mode to 0.5V. However, based on Figure 69, the common mode level would be zero volts, unless there is an internal bias not shown. 

    If you have specific questions about DAC38RF83, I recommend to submit a new E2E post so that it can be assigned to the responsible team.

    Kind regards,
    Lane 

  • 0 in reply to Lane Boyd
    Intellectual 270 points

    Hi Lane,

    There is internal 0.5v bias. and 100ohs deferential termination.

    So, I need to AC couple (0.1u).

    Do I need RESISTOR termination serial\parallel?

     

    Kind regards,

    Shlomi

  • 0 in reply to Shlomi Is'hakov
    TI__Mastermind 29830 points

    Shlomi,

    No additional resistor termination is required. Once the HSDS signal is AC-coupled, the DAC internal termination is all you need.

    Regards,