TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADC12QJ1600EVM: TI-JESD204C-IP, Assertion of “rx_lane_data_valid” 0

    26 views
    0 replies
    Started 16 days ago
    by Hiroshi Oinuma
  • Not Answered

    AFE5401-Q1EVM: How to use GUI. 0

    31 views
    0 replies
    Started 16 days ago
    by Frank Garcia
  • Suggested Answer

    ADS130B04-Q1: ADC behavior after re-sync 0

    56 views
    1 reply
    Latest 17 days ago
    by Joachim Wuerker
  • Answered

    ADC3664EVM: Can't connect to ADC3664EVM by ADC36xxEVM GUI. 0

    150 views
    8 replies
    Latest 17 days ago
    by Kato Yuya
  • Suggested Answer

    TSMU818A030: same code with Xilinx FPGA 0

    101 views
    2 replies
    Latest 17 days ago
    by Chen Alex1
  • Not Answered

    DAC82002: EVM software installation error 1003 - labview 0

    90 views
    3 replies
    Latest 17 days ago
    by Lucas Burnette
  • Not Answered

    ADC3544: DDR I and Q components output same value 0

    115 views
    4 replies
    Latest 17 days ago
    by Luke Allen
  • Answered

    ADS131M08: DS shows it internal reference typ is 1.2V ,but curve shows is 1.18V 0

    69 views
    1 reply
    Latest 17 days ago
    by Keith Nicholas
  • Suggested Answer

    ADS127L21: do you provide IBIS model for ADS127L21? START pin Cin? 0

    57 views
    1 reply
    Latest 17 days ago
    by Keith Nicholas
  • Suggested Answer

    ADC128S102QML-SP: Power supply conditions for VA and VD 0

    58 views
    1 reply
    Latest 17 days ago
    by Joel Meraz
  • Not Answered

    ADS127L21: High Noise and Small Voltage Range Issue with ADS127L21 0

    45 views
    1 reply
    Latest 17 days ago
    by Keith Nicholas
  • Not Answered

    ADC128S102: ADC128S102 Inter modulation distortion 0

    146 views
    8 replies
    Latest 17 days ago
    by Joel Meraz
  • Not Answered

    BQ79616: bq79616 coml communicaiton 0

    52 views
    1 reply
    Latest 17 days ago
    by Benjamin Luty
  • Answered

    AMC131M01: About step response time 0

    132 views
    5 replies
    Latest 17 days ago
    by Saleh Ahmad
  • Answered

    ADS130B02-Q1: required procedure for ads130b02q1 with controller 0

    115 views
    5 replies
    Latest 17 days ago
    by Joachim Wuerker
  • Not Answered

    AFE7950EVM: AFE7950 Evaluation board with TSW14J58EVM 0

    26 views
    0 replies
    Started 17 days ago
    by Thibault Deleu
  • Suggested Answer

    ADC12DJ5200RF-DESIGN: ADC12DJ1600 Hyperlynx Model 0

    57 views
    2 replies
    Latest 17 days ago
    by Frank Shen
  • Suggested Answer

    ADS130B02-Q1: Input voltage limits 0

    35 views
    1 reply
    Latest 17 days ago
    by Joachim Wuerker
  • Suggested Answer

    ADS131M04: Does the differential acquisition of ADS131M04IPWR chip support negative voltage acquisition? 0

    90 views
    3 replies
    Latest 17 days ago
    by Joachim Wuerker
  • Answered

    ADS8686S: Do I need to use resistor when grounding unused parallel lines (Dx) 0

    102 views
    4 replies
    Latest 17 days ago
    by Andreas Nestler
<>