TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADC12DJ5200RF: ADC12DJ5200RF Analog input bandwidth 0 Locked

    376 views
    1 reply
    Latest over 6 years ago
    by Yusuf%20Agoro
  • Suggested Answer

    DAC8771: output over-range 0 Locked

    270 views
    1 reply
    Latest over 6 years ago
    by Garrett Satterfield
  • Answered

    ADS1299: Questions about design with uni-polar power supply, referential montage, and AC lead-off impedance check 0 Locked

    961 views
    4 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Answered

    DAC60501: What is Peak Reflow Temperature ? 0 Locked

    225 views
    2 replies
    Latest over 6 years ago
    by Gowtham Babu
  • Answered

    DAC8771: PVDD/AVDD Power on reset issue 0 Locked

    487 views
    2 replies
    Latest over 6 years ago
    by user5163865
  • Answered

    TLV2548-EP: What is the ESD voltage? 0 Locked

    367 views
    2 replies
    Latest over 6 years ago
    by KAEDE KUDO
  • Suggested Answer

    ADS8688EVM-PDK: sample code 0 Locked

    739 views
    1 reply
    Latest over 6 years ago
    by Dale Li
  • Answered

    ADS8664: An unclear description in datasheet 0 Locked

    532 views
    3 replies
    Latest over 6 years ago
    by Dale Li
  • Suggested Answer

    ADS8363EVM: Interfacing to the TMS320C6748 (C6748 LCDK) 0 Locked

    688 views
    5 replies
    Latest over 6 years ago
    by Tom Hendrick
  • Suggested Answer

    DAC5672A: Request the Test Data. 0 Locked

    494 views
    5 replies
    Latest over 6 years ago
    by Neeraj Gill
  • Suggested Answer

    WEBENCH® Tools/ADS1232REF: ads1232 0 Locked

    346 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS124S08: Scan timing when all channels are being used. 0 Locked

    254 views
    1 reply
    Latest over 6 years ago
    by Joachim Wuerker
  • Suggested Answer

    ADS1220: Internal Reference Voltage 0 Locked

    551 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS7947: 47 ohm source series termination resistor on digital lines? 0 Locked

    512 views
    1 reply
    Latest over 6 years ago
    by Cynthia
  • Suggested Answer

    ADS131A04: Single ended analog input configuration 0 Locked

    537 views
    2 replies
    Latest over 6 years ago
    by user5860225
  • Suggested Answer

    ADS7953: Read PWM signals at input channels 0 Locked

    390 views
    3 replies
    Latest over 6 years ago
    by Cynthia
  • Answered

    ADS131A04: ads131a04 analog input to digit output mapping curve 0 Locked

    856 views
    2 replies
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    DAC8871EVM: EVM overheating and receiving no output from DAC 0 Locked

    809 views
    8 replies
    Latest over 6 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1292: Internal Reference Settle time 0 Locked

    706 views
    2 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Answered

    DAC38RF82EVM: ferrite beads vs three terminal capacitors 0 Locked

    3422 views
    4 replies
    Latest over 6 years ago
    by vic zap
<>