TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    AFE4900: output code will automatically decent after it raises 0 Locked

    221 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
  • Suggested Answer

    CCS/AFE4900EVM: afe4900 ECG 0 Locked

    354 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
  • Answered

    ADS1248: Never data ready 0 Locked

    518 views
    3 replies
    Latest over 6 years ago
    by Josep Izquierdo Moles
  • Answered

    ADS1261EVM: Register map is not visible and device can not be switched back from firmware update 0 Locked

    747 views
    2 replies
    Latest over 6 years ago
    by Matej Njegovec
  • Suggested Answer

    ADS124S06: Differential measurement and ADC counts output 0 Locked

    1734 views
    8 replies
    Latest over 6 years ago
    by Joachim Wuerker
  • Answered

    DDC112: What is manufacture valiation of output data when 22pF capacitor only is connected to IN1 terminal. 0 Locked

    1090 views
    14 replies
    Latest over 6 years ago
    by Kazuya Nakai59
  • Answered

    BOOSTXL-ADS7841-Q1: Cannot get data output from ADS7841-Q1 from TM4C1294XL 0 Locked

    1050 views
    4 replies
    Latest over 6 years ago
    by Cynthia
  • Answered

    ADS1672: Delay of DRDY of ADS1672 0 Locked

    344 views
    2 replies
    Latest over 6 years ago
    by Masami Michino
  • Answered

    ADS7961-Q1: ADS7961 wrong data received on some of the channels 0 Locked

    639 views
    4 replies
    Latest over 6 years ago
    by Cynthia
  • Answered

    ADC12DJ3200: Explanation of Absolute Maximum Ratings for ADC12DJ3200 and DC offset for pulsed applications 0 Locked

    828 views
    8 replies
    Latest over 6 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    DDC264EVM: How to control the DDC264EVM with Matlab? 0 Locked

    547 views
    4 replies
    Latest over 6 years ago
    by Chen Kung
  • Answered

    DAC161S997EVM: Error connecting to Comport 0 Locked

    564 views
    3 replies
    Latest over 6 years ago
    by Juan Martinez40
  • Answered

    DAC37J82EVM: Link establishment fails during ILA sequence 0 Locked

    1691 views
    12 replies
    Latest over 6 years ago
    by Branden Buckner
  • Suggested Answer

    ADS1242: ADS1242 0 Locked

    454 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Answered

    ADS8910B: Setting ADS8910B to Quad-SSI mode with MSP432E401Y 0 Locked

    1024 views
    9 replies
    Latest over 6 years ago
    by Michael Grino
  • Answered

    DAC38RF83: DAC38RF8x_EYE_SCAN software 0 Locked

    247 views
    2 replies
    Latest over 6 years ago
    by Tom Trainer
  • Answered

    DAC38RF80EVM: Verifying DAC/CLK interface without FPGA 0 Locked

    433 views
    6 replies
    Latest over 6 years ago
    by Jared Emerson
  • Suggested Answer

    DAC8771: DAC8771 datasheet questions 0 Locked

    444 views
    1 reply
    Latest over 6 years ago
    by Garrett Satterfield
  • Suggested Answer

    LMP90100: LMP90100 Background Calibration: Gain calibration for the internal PGA with the external reference voltage? 0 Locked

    370 views
    3 replies
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    ADS4225: Using a SDR ADC in a DSO project 0 Locked

    1842 views
    8 replies
    Latest over 6 years ago
    by dBrock
<>