TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS8344: Avoid floating signals on unused analog inputs 0 Locked

    887 views
    1 reply
    Latest over 7 years ago
    by Cynthia
  • Not Answered

    Front-end design of data acquisition system 0 Locked

    1052 views
    4 replies
    Latest over 7 years ago
    by Vivek Gujari
  • Suggested Answer

    AMC7812EVM-PDK: AMC7812EVM-PDK: latest AMC7812EVM Software required 0 Locked

    1500 views
    8 replies
    Latest over 7 years ago
    by Matthew Sauceda
  • Answered

    WEBENCH® Tools/ADS1298ECGFE-PDK: regurding variable resolution set up 0 Locked

    584 views
    2 replies
    Latest over 7 years ago
    by rakesha T
  • Suggested Answer

    ADC3424: Finding a suitable driver with SE to Diff VCM+-0.5V 0 Locked

    5169 views
    15 replies
    Latest over 7 years ago
    by Magnus Sundal
  • Not Answered

    ADS1294R: LF-Noise of the integrated reference. 0 Locked

    1489 views
    6 replies
    Latest over 7 years ago
    by Jürgen Wissenwasser
  • Answered

    DAC3484: Multiple DACs Synchronization 0 Locked

    887 views
    4 replies
    Latest over 7 years ago
    by Vijaya Madhireddy
  • Answered

    ADS7841-Q1: Recommended circuit and some questions 0 Locked

    1048 views
    5 replies
    Latest over 7 years ago
    by Abhijeet Godbole
  • Not Answered

    DAC5682ZEVM: DAC5682ZEVM Drivers are not installing 0 Locked

    1356 views
    5 replies
    Latest over 7 years ago
    by Madan Kumar
  • Not Answered

    ADS1258: achieving 125K samples/sec rate 0 Locked

    1483 views
    5 replies
    Latest over 7 years ago
    by Christopher Hall
  • Not Answered

    ADS42JB49: ADS42JB49 Single end Input 0 Locked

    821 views
    4 replies
    Latest over 7 years ago
    by jim s
  • Answered

    ADS7951: Difference between ADS7951S and ADS7951SB 0 Locked

    668 views
    1 reply
    Latest over 7 years ago
    by Evan Sawyer
  • Answered

    ADS1231REF: Can't enter config mode 0 Locked

    1581 views
    7 replies
    Latest over 7 years ago
    by Evan Davey
  • Answered

    ADS1293EVM: How is the JP2 powered configured for the ADS1293EVM 0 Locked

    1334 views
    5 replies
    Latest over 7 years ago
    by daniel gamez
  • Answered

    ADC12DJ3200EVM: TIme-out error with TSW14j56EVM. D4 LED not blinking. 0 Locked

    1202 views
    6 replies
    Latest over 7 years ago
    by Jim Brinkhurst1
  • Answered

    ADS1220: Use AINx pin to output IDAC and sample voltage the same time 0 Locked

    1756 views
    1 reply
    Latest over 7 years ago
    by Bob Benjamin
  • Suggested Answer

    DAC8775: DAC8775EVM - Accuracy vs Load 0 Locked

    982 views
    1 reply
    Latest over 7 years ago
    by Kevin Duke
  • Suggested Answer

    DAC8775: buck boost converter filtering circuit placement 0 Locked

    1342 views
    7 replies
    Latest over 7 years ago
    by Kevin Duke
  • Answered

    Searching for an ADC EVM or DK that currently has support 0 Locked

    795 views
    1 reply
    Latest over 7 years ago
    by Joseph Wu
  • Answered

    DAC8775EVM: DAC8775EVM - Accuracy vs Load 0 Locked

    519 views
    1 reply
    Latest over 7 years ago
    by Matthew Sauceda
<>