TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    DAC7822: Output voltage for start up timing 0 Locked

    460 views
    1 reply
    Latest over 8 years ago
    by Uttam Sahu
  • Suggested Answer

    DAC7822: Question about internal resistor and output voltage 0 Locked

    1516 views
    7 replies
    Latest over 8 years ago
    by Uttam Sahu
  • Suggested Answer

    Analog isolation IC or other product, suggestion needed 0 Locked

    1844 views
    1 reply
    Latest over 8 years ago
    by Tom Hendrick
  • Answered

    TSW1400EVM: Storing data from ADC4249evm using tsw1400evm 0 Locked

    690 views
    2 replies
    Latest over 8 years ago
    by Mayank Gupta99
  • Suggested Answer

    ADS8698: Sample Source Code for ADS8698 0 Locked

    1435 views
    4 replies
    Latest over 8 years ago
    by Clark Kung
  • Answered

    ADC12D500RF: ADC12D500RF - Spurious at 2Fin 0 Locked

    937 views
    2 replies
    Latest over 8 years ago
    by Jim Brinkhurst1
  • Not Answered

    recommend Software Tool for Medical Device Risk Analysis 0 Locked

    574 views
    1 reply
    Latest over 8 years ago
    by Praveen Aroul
  • Suggested Answer

    ADS127L01: DRDY behaviour and conversion results reading 0 Locked

    1987 views
    5 replies
    Latest over 8 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS8866: Reference driver circuit for Vref=4V 0 Locked

    1326 views
    1 reply
    Latest over 8 years ago
    by Evan Sawyer
  • Answered

    ADS1293: Some question about "BW" definition in datasheet... 0 Locked

    693 views
    1 reply
    Latest over 8 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS1298: ADS1298IPAG 0 Locked

    578 views
    1 reply
    Latest over 8 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS7800: Is the internal Voltage reference used to determine the Digital output value for this ADC. 0 Locked

    721 views
    2 replies
    Latest over 8 years ago
    by Michael Stout
  • Answered

    DAC60004: Signal Integrity Checks - IBIS Model? 0 Locked

    710 views
    1 reply
    Latest over 8 years ago
    by Matthew Sauceda
  • Suggested Answer

    ADS1292R: Can we get source code of MSP430 MCU in ADS1292RECG-FE demo board ? 0 Locked

    811 views
    1 reply
    Latest over 8 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS1299-4: Recalling the ways to get a clean signal 0 Locked

    2798 views
    6 replies
    Latest over 8 years ago
    by Ryan Andrews
  • Answered

    DAC8760: DAC8760 Iout 4 ~ 20mA output question 0 Locked

    1548 views
    3 replies
    Latest over 8 years ago
    by Matthew Sauceda
  • Answered

    TSW1400EVM: TSW1400 0 Locked

    820 views
    2 replies
    Latest over 8 years ago
    by david sun77114
  • Suggested Answer

    ADS8681EVM-PDK: ADS8681EVM-PDK - Facing issue while interfacing with PC/Laptop 0 Locked

    1819 views
    7 replies
    Latest over 8 years ago
    by Sandeep Kasargod
  • Suggested Answer

    ADS8862: ADS8862 - Device enters latchup condition after brownout 0 Locked

    826 views
    3 replies
    Latest over 8 years ago
    by RahulVK
  • Answered

    part selection issues 0 Locked

    1466 views
    7 replies
    Latest over 8 years ago
    by Joachim Wuerker
<>