TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    DAC39RF10-SP: PLL, Serdes error 0 Locked

    224 views
    1 reply
    Latest over 1 year ago
    by Matthew Kramer
  • Suggested Answer

    ADC32RF45EVM: Assistance Required for Firmware Configuration with TSW14J59 and ADC32RF45 EVMs 0 Locked

    322 views
    1 reply
    Latest over 1 year ago
    by Chase W
  • Suggested Answer

    ADC12DJ5200RFEVM: EVM Schematic seems wrong 0 Locked

    248 views
    1 reply
    Latest over 1 year ago
    by Eric Kleckner
  • Answered

    ADC12DJ5200RF: About 20.8GSPS application 0 Locked

    244 views
    1 reply
    Latest over 1 year ago
    by Eric Kleckner
  • Answered

    ADS1258-EP: ADS1258 random reading problem 0 Locked

    205 views
    2 replies
    Latest over 1 year ago
    by ozgur yildiz
  • Suggested Answer

    ADS8528: ADS8528SPM 0 Locked

    223 views
    1 reply
    Latest over 1 year ago
    by Tom Hendrick
  • Suggested Answer

    ADS8422: EVM for ADS8422 0 Locked

    225 views
    1 reply
    Latest over 1 year ago
    by Tom Hendrick
  • Suggested Answer

    ADS8555EVM-PDK: ADS8555EVM-PDK: 0 Locked

    174 views
    1 reply
    Latest over 1 year ago
    by Tom Hendrick
  • Suggested Answer

    ADS8528: Input impedance for analog input 0 Locked

    180 views
    1 reply
    Latest over 1 year ago
    by Tom Hendrick
  • Answered

    TX7316EVM: Use the GUI to automatically switch delay profiles in on-chip mode 0 Locked

    236 views
    1 reply
    Latest over 1 year ago
    by Savyan Kanisserry
  • Answered

    ADS114S06: Is the POR_Flag set on RESET? 0 Locked

    204 views
    1 reply
    Latest over 1 year ago
    by Joachim Wuerker
  • Answered

    DAC37J84EVM: Need to work TSW14J10 with ZCU102. 0 Locked

    319 views
    4 replies
    Latest over 1 year ago
    by Erivelton Castro
  • Answered

    ADS114S08: ADS114S08IPBSR 0 Locked

    245 views
    2 replies
    Latest over 1 year ago
    by Parth Bhavsar
  • Not Answered

    ADS131B04-Q1: Scenarios for use and how to use the calibration function 0 Locked

    269 views
    3 replies
    Latest over 1 year ago
    by Joachim Wuerker
  • Answered

    ADS6145: Question about Analog Input Differential Voltage 0 Locked

    220 views
    2 replies
    Latest over 1 year ago
    by Shinichi Inoue
  • Answered

    ADS1299: Measure using BIAS 0 Locked

    906 views
    18 replies
    Latest over 1 year ago
    by Toan Tran
  • Answered

    ADS8686S: SPI communication via SDOA returning garbage 0 Locked

    810 views
    15 replies
    Latest over 1 year ago
    by Tom Hendrick
  • Answered

    ADS1298: Help with ADC pin voltages 0 Locked

    538 views
    7 replies
    Latest over 1 year ago
    by Mohammed Abouelsoud
  • Not Answered

    AFE4490: Relationship between INN INM and TXP TXN for AFE4400 and AFE4490 0 Locked

    444 views
    1 reply
    Latest over 1 year ago
    by Norihiro Yoshii
  • Suggested Answer

    ADS131M02: ADC always reads 0x8000 no matter what the input analog signal is 0 Locked

    851 views
    12 replies
    Latest over 1 year ago
    by Joachim Wuerker
<>