TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS for Holter monitor (ECG) 0 Locked

    627 views
    1 reply
    Latest over 10 years ago
    by Brian Pisani
  • Answered

    ADS7841 CS 0 Locked

    259 views
    1 reply
    Latest over 10 years ago
    by Harsha Munikoti
  • Answered

    ADS1298FE WCT and Lead-off problem 0 Locked

    1864 views
    14 replies
    Latest over 10 years ago
    by Brian Pisani
  • Answered

    ADS1299 Device ID get over SPI 0 Locked

    4821 views
    22 replies
    Latest over 10 years ago
    by ghalib janjua
  • Not Answered

    delay between clockout and dataout in ads4249 0 Locked

    386 views
    1 reply
    Latest over 10 years ago
    by Matt Guibord
  • Answered

    DAC38J82 buswidth of SERDES and lane config 0 Locked

    3120 views
    15 replies
    Latest over 10 years ago
    by Matt Guibord
  • Answered

    ADS1274 Quasi-Differential Input? 0 Locked

    1238 views
    3 replies
    Latest over 10 years ago
    by Ryan Andrews
  • Answered

    Can ADS1x98ECG FE used for phonocardiogram? 0 Locked

    1093 views
    8 replies
    Latest over 10 years ago
    by Wendi
  • Not Answered

    DAC161S997 - Gain error temperature coefficient, Integral non-linearity 0 Locked

    348 views
    2 replies
    Latest over 10 years ago
    by Hirotaka Matsumoto
  • Not Answered

    Can you give me your AD conversion chip ADC128S022 driver package, thank you 0 Locked

    417 views
    0 replies
    Started over 10 years ago
    by user4352039
  • Not Answered

    Does ADC101S021 have schmitt trigger inputs? 0 Locked

    336 views
    2 replies
    Latest over 10 years ago
    by takishin
  • Answered

    ADS8339EVM-PDK plugin software download 0 Locked

    588 views
    4 replies
    Latest over 10 years ago
    by Harsha Munikoti
  • Answered

    How is an accuracy of ADC088S022 when irregular SCLK is input ? 0 Locked

    330 views
    1 reply
    Latest over 10 years ago
    by Chuck Sins
  • Answered

    AFE4490 - How to use two RX-LEDs ? 0 Locked

    508 views
    2 replies
    Latest over 10 years ago
    by Amy Schnoor
  • Not Answered

    Method to calculate Heart rate from ADC output code for a Smart watch HRM based on AFE4400 0 Locked

    931 views
    6 replies
    Latest over 10 years ago
    by Amy Schnoor
  • Not Answered

    Problems about the AFE4400 LED Configuration and denoising. 0 Locked

    742 views
    3 replies
    Latest over 10 years ago
    by Amy Schnoor
  • Suggested Answer

    ADS1298ECGFE-PDK : Connecting with Electrodes 0 Locked

    828 views
    3 replies
    Latest over 10 years ago
    by Brian Pisani
  • Not Answered

    TS12A4516 0 Locked

    359 views
    0 replies
    Started over 10 years ago
    by Jeff Wang25
  • Not Answered

    ADCPro nearly unusable 0 Locked

    623 views
    4 replies
    Latest over 10 years ago
    by Brian Kuschak
  • Answered

    ADS7853 anti-aliasing filter and internal reference 0 Locked

    654 views
    1 reply
    Latest over 10 years ago
    by Luis Chioye
<>