TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS125H01: Relationship between external clk and sampling rate 0 Locked

    241 views
    2 replies
    Latest over 1 year ago
    by Shinichi Inoue
  • Answered

    ADS127L01: efficient CRC-4-ITU implementation? 0 Locked

    853 views
    3 replies
    Latest over 1 year ago
    by Carl Kugler
  • Answered

    ADS1015: Statement of Volatility 0 Locked

    340 views
    2 replies
    Latest over 1 year ago
    by James Fasolino
  • Answered

    ADS8881: Bipolar Input 0 Locked

    265 views
    2 replies
    Latest over 1 year ago
    by Samiha Sharif
  • Suggested Answer

    ADS1015: Letter of Volatility Requested 0 Locked

    382 views
    1 reply
    Latest over 1 year ago
    by Angel Rodriguez de San Miguel Bermudez
  • Not Answered

    ADS131M06: Issues with Communication Stability 0 Locked

    269 views
    3 replies
    Latest over 1 year ago
    by Dale Li
  • Not Answered

    ADS7953: Channels Noise Issue 0 Locked

    253 views
    1 reply
    Latest over 1 year ago
    by Joel Meraz
  • Answered

    DAC8760: Maximum output power less than 20mA 0 Locked

    461 views
    6 replies
    Latest over 1 year ago
    by Joseph Wu
  • Suggested Answer

    ADC128S102QML-SP: 5962R0722701VZA (ADC128S102QML) -Absolute max clarification and ESD diode/reverse current operation +1 Locked

    218 views
    1 reply
    Latest over 1 year ago
    by Joel Meraz
  • Answered

    ADS8681: DEVICE_ID_REG register default value 0 Locked

    355 views
    9 replies
    Latest over 1 year ago
    by HIEP HUYNH
  • Suggested Answer

    DAC7512: ESD Info 0 Locked

    210 views
    1 reply
    Latest over 1 year ago
    by Katlynne Jones
  • Suggested Answer

    ADS1299EEGFE-PDK:ADS1299EEGFE-PDK 0 Locked

    445 views
    7 replies
    Latest over 1 year ago
    by Junzhe Zhang
  • Suggested Answer

    ADC32RF54EVM: Missing schematics files 0 Locked

    214 views
    1 reply
    Latest over 1 year ago
    by Chase W
  • Answered

    TLA2518: Powering up only DVDD (the interface side) of the converter 0 Locked

    189 views
    2 replies
    Latest over 1 year ago
    by mjan
  • Answered

    AMC60704: How to measure INL & Gain errors? 0 Locked

    287 views
    2 replies
    Latest over 1 year ago
    by Andrew Su
  • Answered

    ADC3910D125: statistics engine problem 0 Locked

    378 views
    3 replies
    Latest over 1 year ago
    by Fadi Matloob
  • Suggested Answer

    ADC08100: TI P2P solution to replace AD7997BRUZ-0REEL 0 Locked

    247 views
    2 replies
    Latest over 1 year ago
    by Josh Brown
  • Suggested Answer

    ADS1271: Can the ads1271 be used for a 6.5 multimeter? 0 Locked

    296 views
    1 reply
    Latest over 1 year ago
    by Keith Nicholas
  • Suggested Answer

    ADC121C021: ADC121C021CIMK/NOPB 0 Locked

    241 views
    1 reply
    Latest over 1 year ago
    by Joel Meraz
  • Suggested Answer

    LM51772: spec check 0 Locked

    570 views
    7 replies
    Latest over 1 year ago
    by Stefan Schauer
<>