TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    TMS470R1B1M going below -40C storage temp 0 Locked

    573 views
    2 replies
    Latest over 12 years ago
    by Wade Vonbergen
  • Not Answered

    ADS1610 + ??? 0 Locked

    200 views
    2 replies
    Latest over 12 years ago
    by Jerry J
  • Not Answered

    TPS40200 Failure 0 Locked

    275 views
    1 reply
    Latest over 12 years ago
    by Richard Biddle
  • Answered

    ADC12D1800: Balun Board for DESIQCLK Mode 0 Locked

    1158 views
    1 reply
    Latest over 12 years ago
    by Marjorie Plisch
  • Answered

    ADS 1278 queries 0 Locked

    297 views
    3 replies
    Latest over 12 years ago
    by junaid ehsan
  • Answered

    Drivers for ADS1293 0 Locked

    2868 views
    15 replies
    Latest over 12 years ago
    by Sergio
  • Not Answered

    ADS1298 - DRDY back to high with any SCLK? 0 Locked

    435 views
    2 replies
    Latest over 12 years ago
    by Bernhard Wandernoth
  • Answered

    About Supertex MD2131's TI equivalent 0 Locked

    586 views
    3 replies
    Latest over 12 years ago
    by Hasan Yetik
  • Answered

    Problem with ADC installation 0 Locked

    328 views
    2 replies
    Latest over 12 years ago
    by Mahendra Patel1
  • Answered

    ADS1248 EVM Internal Reference 0 Locked

    495 views
    7 replies
    Latest over 12 years ago
    by Bob Benjamin
  • Discussion

    ADS1292R (momentary input current) Locked

    706 views
    6 replies
    Latest over 12 years ago
    by HECTOR
  • Not Answered

    DDC114 CLK Source 0 Locked

    222 views
    0 replies
    Started over 12 years ago
    by mrmrlarry
  • Answered

    ADS41B49 + LSW1200 0 Locked

    321 views
    2 replies
    Latest over 12 years ago
    by Jaroslav Koton
  • Answered

    DAP signal conditioning board (DAPSIGCNDBRDUNPEVM) 0 Locked

    325 views
    1 reply
    Latest over 12 years ago
    by Tom Hendrick
  • Answered

    Using the ADS7886 with bipolar inputs 0 Locked

    298 views
    2 replies
    Latest over 12 years ago
    by will jongenelen
  • Answered

    Trouble using DAC7562 0 Locked

    2108 views
    19 replies
    Latest over 12 years ago
    by Tim Scott
  • Answered

    ADS1259 EVM interfacing problem 0 Locked

    340 views
    1 reply
    Latest over 12 years ago
    by Bob Benjamin
  • Answered

    ADS1259 without buffer at input 0 Locked

    1219 views
    12 replies
    Latest over 12 years ago
    by Bob Benjamin
  • Answered

    Are TI part numbers beginning JM38510 and M38510 the same? 0 Locked

    1577 views
    1 reply
    Latest over 12 years ago
    by Richard Biddle
  • Not Answered

    LMP90100 for (multiple) strain gauge measurement 0 Locked

    455 views
    2 replies
    Latest over 12 years ago
    by Pelgrims Patrick
<>