TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS8634: Converted data out does not match data sheet 0 Locked

    317 views
    1 reply
    Latest over 3 years ago
    by Steve Trigero
  • Answered

    TSW1400EVM: Can't get TSW1400_pattern_gen to work 0 Locked

    274 views
    5 replies
    Latest over 3 years ago
    by Chase W
  • Answered

    ADS7870: Design Verification 0 Locked

    536 views
    5 replies
    Latest over 3 years ago
    by Cynthia
  • Suggested Answer

    AMC7836: Clamp oupput load current 0 Locked

    202 views
    1 reply
    Latest over 3 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1219: Possible Mistake in datasheet 0 Locked

    392 views
    1 reply
    Latest over 3 years ago
    by Bob Benjamin
  • Answered

    ADS7254: Question regarding sampling a single ended signal. 0 Locked

    274 views
    1 reply
    Latest over 3 years ago
    by Aaron Estrada
  • Answered

    ADS5294: Abnormally high VCM = 1.15V 0 Locked

    570 views
    8 replies
    Latest over 3 years ago
    by Abhishek Vishwa1
  • Not Answered

    AFE5832LPEVM: HDL reference code 0 Locked

    363 views
    1 reply
    Latest over 3 years ago
    by Abhishek Vishwa1
  • Suggested Answer

    DAC80508: SDO State with VDD Off 0 Locked

    401 views
    7 replies
    Latest over 3 years ago
    by Shinichi Yokota
  • Answered

    ADS131A02: CLK in Multiple Device Configuration 0 Locked

    262 views
    2 replies
    Latest over 3 years ago
    by Kurumi Hasegawa
  • Not Answered

    DAC81416: No output 0 Locked

    711 views
    11 replies
    Latest over 3 years ago
    by Lucas Burnette
  • Suggested Answer

    ADS8343: Reference code 0 Locked

    313 views
    1 reply
    Latest over 3 years ago
    by Cynthia
  • Suggested Answer

    ADS1274: Depopulating unused channels - how to best terminate? 0 Locked

    213 views
    1 reply
    Latest over 3 years ago
    by Keith Nicholas
  • Answered

    ADS1274: ADS1274 IEPE 4 Channels design +1 Locked

    635 views
    3 replies
    Latest over 3 years ago
    by Keith Nicholas
  • Answered

    DAC70502: bit1/0 on DAC data 0 Locked

    264 views
    1 reply
    Latest over 3 years ago
    by Illia Volkov
  • Answered

    ADS7138-Q1: NACK from Host is allowed? 0 Locked

    249 views
    3 replies
    Latest over 3 years ago
    by Cynthia
  • Answered

    ADC12D1620QML-SP: TSW12D1620 Evaluation module 0 Locked

    595 views
    9 replies
    Latest over 3 years ago
    by Neeraj Gill
  • Suggested Answer

    DAC60508: DAC60508MCRTET with/without external Vref REF3325AIRSER 0 Locked

    221 views
    3 replies
    Latest over 3 years ago
    by Paul_Frost
  • Suggested Answer

    ADC12DJ3200QML-SP: ADC input to serializer output latency - Subclass 0 (No SYSREF) 0 Locked

    283 views
    2 replies
    Latest over 3 years ago
    by Neeraj Gill
  • Answered

    ADS124S08EVM: Measure Thermistor with ADS124S08EVM 0 Locked

    464 views
    4 replies
    Latest over 3 years ago
    by Bob Benjamin
<>