TPD4E02B04-Q1: Can it be also using for DM, DP, CC1 and CC2 pins

Mehmet COBAN

Intellectual 275 points

Part Number: TPD4E02B04-Q1
Other Parts Discussed in Thread: TVS0500, TPD1E10B06, TPD1E05U06, TPD4E02B04, ESD122

Hi Erika,

I hope you are doing good.

I want to put my design to esd protection. That's why, I realized TPD4E02B04-Q1 ESD Protection Diode.

However I am not doing high speed design. I am doing only USB charging the USB Type-C ports. (DCDC Converter, USB 2.0).

Can this diode also using for DM, DP, CC1 and CC2 pins?

the reason why I insist on using this diode is because it is bidirectional. Other ones are unidirectional.

Best,

Mehmet ÇOBAN

over 2 years ago

0 Matt Smith3 over 2 years ago

TI__Expert 8471 points

Hi Mehmet,

I'm assuming you also want to protect the Vbus pin as well if you are doing USB-C charging. Can you tell me the voltage level on the Vbus pin? There are multiple voltage levels depending on what type of charging you are doing.

Regards,

Matt Smith

0 Mehmet COBAN over 2 years ago in reply to Matt Smith3

Intellectual 275 points

Hi Matt,

Thank you for your response.

The Voltage level on Vbus pin is 5V.

Regards,

Mehmet

+1 Matt Smith3 over 2 years ago in reply to Mehmet COBAN

TI__Expert 8471 points

Hi Mehmet,

For the Vbus pin, I would recommend using either TVS0500 or TPD1E10B06. For the CC pins, I would recommend using TPD1E05U06. For the D+/D- pins, I would recommend using ESD122. TPD4E02B04 would not work because the CC pins go up to 5 V and TPD4E02B04 is only a 3.6 V device. You can refer to pages 6-8 of this app note for more details: https://www.ti.com/lit/an/slvaf82/slvaf82.pdf?ts=1643813590176&ref_url=https%253A%252F%252Fwww.ti.com%252Finterface%252Fcircuit-protection%252Fesd-surge-protection-ics%252Ftechnical-documents.html

Regards,

Matt

Interface

Interface forum

TPD4E02B04-Q1: Can it be also using for DM, DP, CC1 and CC2 pins