Hi team,
My customer uses DS110DF410 between fiber interface and FPGA. They would like to know which mode(0/1/2/3) is normally used in this case.
Could you please help give some suggestions? Thanks in advance!
Regards,
Ivy
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi team,
My customer uses DS110DF410 between fiber interface and FPGA. They would like to know which mode(0/1/2/3) is normally used in this case.
Could you please help give some suggestions? Thanks in advance!
Regards,
Ivy
Hi Ivy,
Although this is application dependent, I have seen Adapt Mode 1 yield good performance for DS110DF410 with fiber interface in the past.
If the customer is able, we recommend testing with Adapt Modes 2 and 3 as well to see if there is any notable difference in BER.
Thank you,
Evan