SN75LVCP600S: Open the Control Pins

DAE SUN Kang

Prodigy 40 points

Part Number: SN75LVCP600S

Hi,

Can I leave the control pin open if I want a GND condition?

Thanks.

11 months ago

0 Nasser Mohammadi 11 months ago

TI__Guru* 91440 points

Greetings,

Yes if default or GND settings meets your requirement. In general, it is a good practice to use a low value Resistor - for example 1K ohm - to tie control pins to GND. This is because if there is some spikes on the GND this will protect the input.

Regards,Nasser

Interface

Interface forum

SN75LVCP600S: Open the Control Pins