Other Parts Discussed in Thread: TCA9517, SN74LXC1T45
5Vと3.3Vの双方向レベル変換に「TCA3-Q3」を使用することを検討しています。プルダウン抵抗を3.3Vシステム入出力端子に挿入し、プルアップ抵抗を5Vシステム入出力端子に挿入します。電源投入時にローレベル(0V)に設定したいのですが。質問は次のとおりです:
1.「TCA9517-Q1」の使用に問題はありますか?
2. プルダウン抵抗値の計算方法を教えてください。
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
5Vと3.3Vの双方向レベル変換に「TCA3-Q3」を使用することを検討しています。プルダウン抵抗を3.3Vシステム入出力端子に挿入し、プルアップ抵抗を5Vシステム入出力端子に挿入します。電源投入時にローレベル(0V)に設定したいのですが。質問は次のとおりです:
1.「TCA9517-Q1」の使用に問題はありますか?
2. プルダウン抵抗値の計算方法を教えてください。
Hi Ssatake,
Please elaborate on what you mean by TCA3-Q3.
What are you trying to do with the pull-down resistor on the TCA9517-Q1? The 9517 uses internal buffer drivers to re-drive the I2C signal to a low logic. Pull-ups are required in order for the signal to rise back to logic high voltage. Why do you need to pull-down an input upon startup of the 9517?
The supply voltage range from 3.3V to 5V will work for the TCA9517.
Regards,
Tyler
It is not possible to use an auto-bidirectional translator for the SDI-12 data line.
You need a direction-controlled translator like the SN74LXC1T45. If your MCU uses separate input and output pins, add a series resistor at the output so that the MCU does not conflict with the A pin when the direction is B to A.
Hi Ssatake,
In addition to Clemens comments, what is the voltage level of the serial data line in your SDI-12 application? Is the 12 volt line required in SDI-12 also a factor when using the TCA9517?
Regards,
Tyler