DP83822I: The procedure of loopback

Atsushi Takahashi

Part Number: DP83822I

Hi Team,

Please tell me the procedure for using each loopback function.
Can the user get started by simply doing the following?
If no, please tell me correct procedure.

MII Loopback:
Set register address 0x0000[14]=1b

Near-end Loopback:
Set register address 0x0016[4:0]
　00001 = PCS Input Loopback
　00010 = PCS Output Loopback
　00100 = Digital Loopback

Far-end Loopback:
Set register address 0x0000[14]=1b

Reverse Loopback:
Set register address 0x0016[4:0]=10000b

Best Regards,

8 months ago

0 Gerome Cacho 7 months ago

TI__Mastermind 31385 points

Hello,

Far-end and reverse loopback are synonymous. For analog or digital loopback, it is advised to disabled auto-negotiation and auto-mdix.

Sincerely,

Gerome

0 Atsushi Takahashi 7 months ago in reply to Gerome Cacho

Intellectual 855 points

Hi Gerome-san,

Thank you for your reply.

For analog or digital loopback, I'll advise the customer to disable auto-negotiation and auto-mdix.

And I understood Far-end and reverse loopback are synonymous.

Are the other procedure correct?

+1 Gerome Cacho 7 months ago in reply to Atsushi Takahashi

TI__Mastermind 31385 points

Hello,

Everything else looks okay.

Sincerely,

Gerome

0 Atsushi Takahashi 7 months ago in reply to Gerome Cacho

Intellectual 855 points

Hi Gerome-san,

Sorry, I have an additional question.

What's the purpose to do software reset at this timing?

0 Gerome Cacho 7 months ago in reply to Atsushi Takahashi

TI__Mastermind 31385 points

Hello Takahashi-san,

Could you please provide more context? Software reset is used to wipe PHY configurations back to initial.

Sincerely,

Gerome

Interface

Interface forum

DP83822I: The procedure of loopback