• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 32 subscribers
  • Views 138 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TLIN1029A-Q1: Variable Resistor on LIN (pin6)

Shotaro Sakai
Intellectual 2550 points
Part Number: TLIN1029A-Q1
Other Parts Discussed in Thread: ESD751-Q1, ESD1LIN24-Q1

Hello team,

My customer is asking me about the below item. Can you tell me your opinion?

<Question>

- Is it OK to place a chip varistor between LIN(pin6) and GND? 

<Spec of the varistor>

Maximum permitted circuit voltage: 26V
Varistor Voltage Range: 30.6 to 37.4V
Varistor Voltage (Tolerance): 33V
Max. Specified capacitance: 100pF

<Background>

- My customer is doing a surge test based on IEC61000-6-2. The surge voltage is applied to LIN(pin6).

- They tried 2 tests. (Place of 1. Zener diode, 2. TVS diode:  ESD751-Q1 and ESD1LIN24-Q1)

- But the tests was fail. Pin 6 was broken by the surge voltage. So they are considering to apply a chip varistor.

Best regards,

Shotaro

  • +1
    TI__Genius 10595 points

    Hi Shotaro,

    TLIN1029A does not meet the requirement of IEC61000-6-2, which is EMC immunity for industrial environment. Those ESD diodes they used ESD protection components can provide automotive level ESD protection according to IEC61000-4-2. Regarding their question, it is OK to use a varistor as ESD protection. 

    Regards,

    Sean