TLIN1021-Q1: WAKE pin with R4 and R5

Jeffrey Chung1

Part Number: TLIN1021-Q1
Other Parts Discussed in Thread: TLIN1021A-Q1, TCAN1043A-Q1

Tool/software:

Hi Eric,

I have one more question about original thread. Customer is trying to change the value of R4 and R5 resistors.(R4: 3kohm to 4.7kohm, R5: 33kohm to 47kohm) Are there any issues on WAKE function? Please check it and let me know.

Regards,

over 2 years ago

0 Eric Hackett over 2 years ago

TI__Guru 74922 points

Jeffrey,

The calculation the resistor network for the WAKE pin is described in the datasheet. Please let the customer know to use this section of the datasheet to calculate these values.

Regards,

Eric Hackett

0 Jeffrey Chung1 over 2 years ago in reply to Eric Hackett

Genius 3450 points

Hi Eric,

I couldn't find the section of the datasheet to calculate the resistor values. Please let me know the section number of datasheet.

Regards,

+1 Eric Hackett over 2 years ago in reply to Jeffrey Chung1

TI__Guru 74922 points

Jeffrey,

My mistake, it is not included in the datasheet. On our other transceivers with WAKE, the explanation is as follows:

Please let us know if there are any other questions.

Regards,

Eric Hackett

0 Jeffrey Chung1 over 2 years ago in reply to Eric Hackett

Genius 3450 points

Hi Eric,

Please let me know the exact part number of other transceiver with WAKE.

Regards,

0 Eric Hackett over 2 years ago in reply to Jeffrey Chung1

TI__Guru 74922 points

Jeffrey,

That is taken from the TCAN1043A-Q1 datasheet, but the concept is the same. The TLIN1021A-Q1 is the only single-channel LIN transceiver with WAKE that we have in our portfolio.

Regards,

Eric Hackett

Interface

Interface forum

TLIN1021-Q1: WAKE pin with R4 and R5