TMDS181: Using the TUSB3410 to interface to TMDS181 for EyeScan tool

Erich Vogel

Part Number: TMDS181
Other Parts Discussed in Thread: TUSB3410

Can I use the TUSB3410 EVM to jumper over to my TMDS181 device over I2C and run the EyeScan tool? Is there something special I need to do on the EVM to enable this, such as special firmware?

Thank you,

Erich

over 4 years ago

0 David (ASIC) Liu over 4 years ago

TI__Guru**** 153811 points

Erich

The TUSB3410UART EVM interfaces between USB and UART. To use the EVM for the TMDS181 eye scan tool, you need to update the firmware so it is interfacing between USB and I2C.

You can use the TUSB3x10 EEPROM burner to update the firmware. The tool is available at http://www.ti.com/product/TUSB3410/toolssoftware. Please accept my friendship request and I will send you the firmware.

Thanks

David

0 Erich Vogel over 4 years ago in reply to David (ASIC) Liu

Prodigy 45 points

David,

I did not receive your firmware yet. I just am making sure I accepted your friendship correctly. Should I receive an email or do I get this on the website?

Erich

0 David (ASIC) Liu over 4 years ago in reply to Erich Vogel

TI__Guru**** 153811 points

Erich

I sent you a private message that includes the firmware, please check.

Thanks

David

0 Erich Vogel over 4 years ago in reply to David (ASIC) Liu

Prodigy 45 points

Got it. Thank you,

Erich

Interface

Interface forum

TMDS181: Using the TUSB3410 to interface to TMDS181 for EyeScan tool