THVD8000: Carrier frequency appearing on Receive Data Output pin of THVD8000 when in receiver mode.

Paul,

The gerber file is attached.

THVD8000_Gerber.zip

I apologize for the delay.

Regards,

Hao

Hello Hao,

The files you sent look like they are for a different part, the Gerber files call it out as an INT116 REV A board.

Paul

Paul,

Sorry for the confusion. INT116 is the internal assigned board name for THVD8000EVM. Please let me know if you have any question.

Regards,

Hao

Hi Hao,

Please check the files you sent me.

Regards,

Paul

Paul,

I just checked the zip file myself and it includes gerbers and ODB files of the EVM for THVD8000. Is there something else you need?

Regards,

Hi Eric,

Ok, now you're making me doubt my sanity.  I've checked both the Gerber and ODB files...  Both sets of files are for the same board, it's a 2" x 2" board that the ODB files say is for a TRS3232EVM.  I'm looking for the THVD8000 EVM which is roughly 4" x 6" board.  It's a 4 layer board with routing on the outside layers and power and ground on the two internal layers.

Regards,

Paul

Paul,

You are correct, sorry for my mistake, I was looking at my internal files rather than the ones Hao provided. 

Hao,

It looks like you provided files for the TRS3232RGTEVM (INT116) rather than the THVD8000EVM (INT122). 

Regards,

Paul,

I'm so sorry I didn't realize the mistake. Here are the files of THVD8000 (INT122).

INT122_Gerber.zip

Hi Hao,

No problem, I'm just glad you made the mistake not me;-)

Thanks,

Paul

Paul,

It's a 4-layer board, while the middle two layers are ground and Vcc.

Regards,

Hao