TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS90UB960-Q1: BIST Duration

    ReedKacz
    ReedKacz
    Part Number: DS90UB960-Q1 Hi Team, What is the recommended duration to run the BIST? Thanks Reed
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select correct RGMII delay mode for PHY and MAC?

    Vikram Sharma
    Vikram Sharma
    RGMII standard asks for the introduction of delay in the clock (RX_CLK/TX_CLK) with respect to the respective data (RX_D*/RX_CTRL or TX_D*/TX_CTRL). This delay can be introduced at the source of the clock or at the receiver side. Following table should…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select the crystal's ppm specification for an Ethernet system?

    Vikram Sharma
    Vikram Sharma
    Other Parts Discussed in Thread: DP83TC811 Ethernet data travels effectively from one MAC to another MAC with two Ethernet PHYs in between. Each of these 4 ICs can have their own reference clocks and crystal attached to each is the usual source of this…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: DP83867 digital loopback fail, how to set MII and PCS loopback

    Richard Yang1
    Richard Yang1
    Part Number: DP83867IR Hi Team: Customer side need our help to find the root cause of DP83867 Communication failure issue from one failed board . could you please help to take a look at the attached , customer need to know How to enable MII and PCS…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] RGMII Timing - Align and Shift mode

    Gokul Koraganji
    Gokul Koraganji
    Definitions: TX_DATA[3:0], TX_CLK (naming of TI Ethernet PHYs) are transmitted by the MAC/(Repeater PHY) and RX_DATA[3:0], RX_CLK (naming of TI Ethernet PHYs) are transmitted by Ethernet PHY. S.No Mode Definition 1 PHY: RX Align…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UB933-Q1: DS90UB933-Q1 and DS90UB913A-Q1 MODE Decode

    Casey McCrea
    Casey McCrea
    Part Number: DS90UB933-Q1 Other Parts Discussed in Thread: DS90UB913A-Q1 , How do I determine if the DS90UB933-Q1 or DS90UB913A-Q1 device is operating in RAW10, RAW12LF, or RAW12HF through registers?
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] Demystifying Surge Protection

    Matt Smith
    Matt Smith
    Please refer to the links below to access our content related to Demystifying Surge Protection: Videos https://training.ti.com/getting-started-interface-protection White paper https://www.ti.com/lit/pdf/slyy152
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] ESD Fundamentals Training

    Matt Smith
    Matt Smith
    Please refer to the links below to access our ESD Fundamentals training: Videos https://training.ti.com/getting-started-interface-protection Blog Posts Part 1: https://e2e.ti.com/blogs_/b/powerhouse/posts/esd-fundamentals-part-1-what-is…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] ESD and TVS Protection Devices: Key Collateral and FAQs

    Matt Smith
    Matt Smith
    Please use the links below to access our top collateral/FAQs to learn all about protection devices, ESD and surge standards, and how to properly protect your system from ESD and surge events. [FAQ] What TI ESD/TVS diode should I use to protect Interfaces…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select TI High Speed Mux devices?

    Brian Zhou
    Brian Zhou
    There are many Mux devices in TI high speed portfolio, sometimes it's not easy to select a right part for a particular application. This FAQ is used to help FAE or customer to choose the right Mux device based on Mux performance, channel numbers, protocols…
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    maximum distances versus bitrate of M-LVDS 0 Locked

    521 views
    1 reply
    Latest over 15 years ago
    by Saleem Marwat
  • Not Answered

    Question concerning SN65LVDS387 cabling 0 Locked

    411 views
    0 replies
    Started over 16 years ago
    by Miguel Robertson
  • Not Answered

    SN65LV1224B Ref Clock 0 Locked

    482 views
    1 reply
    Latest over 16 years ago
    by HA
  • Not Answered

    Need LVDS TxRx to drive Cat 5E at 200Mhz for 100 meters 0 Locked

    607 views
    1 reply
    Latest over 16 years ago
    by Xavier Ramus
  • Not Answered

    SN65LVDT388A DBT package: Simple Design Question! 0 Locked

    660 views
    1 reply
    Latest over 16 years ago
    by nancy!
  • Not Answered

    PCF8574 Reading bits back 0 Locked

    479 views
    2 replies
    Latest over 16 years ago
    by DHarmon
  • Not Answered

    TL16CP554APM - Rx problem 0 Locked

    380 views
    0 replies
    Started over 13 years ago
    by Ziga Kalan
  • Not Answered

    scansta111 scansta112 chips 0 Locked

    482 views
    0 replies
    Started over 13 years ago
    by Victor
<