TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Lucas Wolter
    Lucas Wolter
    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ESD2CAN24-Q1: ΔCd Parameter confirmation. 0 Locked

    130 views
    1 reply
    Latest 11 months ago
    by McKenzie Eaker
  • Answered

    TUSB2046I: Maximum Reflow Temperature 0 Locked

    200 views
    3 replies
    Latest 11 months ago
    by Brian Zhou
  • Answered

    TMUXHS4212: SEL issue 0 Locked

    294 views
    7 replies
    Latest 11 months ago
    by Brian Zhou
  • Answered

    SN65DP141: Question about how to calculate trace length 0 Locked

    157 views
    2 replies
    Latest 11 months ago
    by Vishesh Pithadiya
  • Suggested Answer

    HD3SS6126EVM: HD3SS6126EVM 0 Locked

    240 views
    3 replies
    Latest 11 months ago
    by Ryan Kitto
  • Suggested Answer

    SN65DSI85EVM: SN65DSI85EVM BGA Design Files required 0 Locked

    184 views
    1 reply
    Latest 11 months ago
    by Vishesh Pithadiya
  • Suggested Answer

    SN65DSI84-Q1: SN65DSI84TPAPRQ- 64-Pin HTQFP || Device Driver provided by TI and I2C confirmation (0x2C or 0x58 when ADDR-PIN#64 set to GND) 0 Locked

    217 views
    1 reply
    Latest 11 months ago
    by David (ASIC) Liu
  • Suggested Answer

    TCAN330: Is it a recommended material 0 Locked

    188 views
    1 reply
    Latest 11 months ago
    by Michael Ikwuyum
  • Suggested Answer

    TUSB522P: Required MTBD and FIR value for the part "TUSB522PIRGER" 0 Locked

    190 views
    2 replies
    Latest 11 months ago
    by David (ASIC) Liu
  • Answered

    TPD4E05U06: s-parameters report 0 Locked

    124 views
    1 reply
    Latest 11 months ago
    by McKenzie Eaker
  • Answered

    THVD1400: Input tolerant 0 Locked

    171 views
    1 reply
    Latest 11 months ago
    by Clemens Ladisch
  • Answered

    PCF8574: Datasheet does not specify connection of thermal pad 0 Locked

    134 views
    1 reply
    Latest 11 months ago
    by Clemens Ladisch
  • Answered

    DP83TC812R-Q1: How to verify force sleep mode +1 Locked

    202 views
    1 reply
    Latest 11 months ago
    by Mike Chang
  • Answered

    LMH0324: LMH0324 IBIS-AMI model 0 Locked

    236 views
    2 replies
    Latest 11 months ago
    by Edu Lee
  • Answered

    PCA9306: Enable the translator causing swing on Vref1 0 Locked

    330 views
    10 replies
    Latest 11 months ago
    by Clemens Ladisch
  • Answered

    TUSB9261: SPI Flash device 0 Locked

    488 views
    10 replies
    Latest 11 months ago
    by xiang zhou
  • Answered

    2N7001T-Q1 Voh and Vol values when VCCA and VCCB not the same voltage. 0 Locked

    160 views
    2 replies
    Latest 11 months ago
    by William Weishaupt
  • Answered

    TCAN1042HV-Q1: Could you please help check the schematic design of TCAN1042HV-Q1 to see if there is any problem 0 Locked

    207 views
    2 replies
    Latest 11 months ago
    by Michael Ikwuyum
  • Answered

    DS125BR401AEVM: CAD Model 0 Locked

    163 views
    1 reply
    Latest 11 months ago
    by Drew Miller1
  • Answered

    TUSB522P: Difference between a redriver and a repeater 0 Locked

    460 views
    1 reply
    Latest 11 months ago
    by Shane Hauser
<>