TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83TC812S-Q1: How to to adjust slew rate of MAC IOs

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Reducing the slew rate of MAC interface IOs can provide improvement in EMC emissions for some frequencies. This can be done using register 0x456. 0x456 bits [5] and [0] control the impedance of the RX and TX MAC interface…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Announcing New GUI Application for Ethernet EVM & PHY Evaluation

    Evan Mayhew
    Evan Mayhew
    All, Excited to share the initial release of DIEP (Debug Interface for Ethernet PHYs). The Windows GUI is designed to simplify the process for PHY-level configuration and debug with register access. Using a valid USB connection to an on-board MSP…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] SN65DSI84: Swapping between DSI 83/84/85

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: SN65DSI84 Other Parts Discussed in Thread: SN65DSI83 , , SN65DSI85 Swapping DSI 83/84/85 FAQ Before we begin here is a brief overview of each part and its capabilities: SN65DSI83: SINGLE channel MIPI DSI to SINGLE channel LVDS Bridge…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TDP1204: What is the difference between the TDP1204 and the TMDS1204 HDMI 2.1 redrivers?

    Zach Dryer
    Zach Dryer
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 When choosing to design in either TDP1204 and TMDS1204, the system designer should consider the differences between the two HDMI 2.1 redrivers. This thread highlights the differences and provides…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: SGMII Output Differential Voltage Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The SGMII Output spec is slightly ambiguous, the purpose of this FAQ is to clear up the terminology. Our data sheet has the following spec: SGMII OUTPUT Min Typ Max Unit Output Differential Voltage …
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to Confirm Ethernet PHY Strapping

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Other Parts Discussed in Thread: DP83869 Our Ethernet PHYs have Hardware Bootstraps that allow the PHY to be configured without the need for register access and also set the PHY ID. Either one of these being mismatched can cause issues, e.g. PHY is configured…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83826I: How do I debug a PHY issue within an EtherCAT network?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826I 3644.How to debug PHY level issues in EtherCAT networks.pdf
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] 10base-T and 10 base-Te difference

    Hillman Lin
    Hillman Lin
    What is the difference between 10Base-T and 10Base-Te?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E-EVM: How to use ping and iperf between two PCs through 510EVM Link?

    Evan Mayhew
    Evan Mayhew
    Part Number: DP83TD510E-EVM ping&iperf_510.ppt
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: How does pin 29 on DP83826 act depending on strap mode?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E DP83826 in Enhanced mode has a pin which is GPIO, pin 29. This pin can be an LED or can be used as CRS. When PHY is set in RMII mode, this pin can be reprogrammed to be LED or CRS. When MII is strapped, this pin is forced to be CRS…
    • over 2 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    maximum distances versus bitrate of M-LVDS 0 Locked

    521 views
    1 reply
    Latest over 15 years ago
    by Saleem Marwat
  • Not Answered

    Question concerning SN65LVDS387 cabling 0 Locked

    411 views
    0 replies
    Started over 16 years ago
    by Miguel Robertson
  • Not Answered

    SN65LV1224B Ref Clock 0 Locked

    482 views
    1 reply
    Latest over 16 years ago
    by HA
  • Not Answered

    Need LVDS TxRx to drive Cat 5E at 200Mhz for 100 meters 0 Locked

    607 views
    1 reply
    Latest over 16 years ago
    by Xavier Ramus
  • Not Answered

    SN65LVDT388A DBT package: Simple Design Question! 0 Locked

    660 views
    1 reply
    Latest over 16 years ago
    by nancy!
  • Not Answered

    PCF8574 Reading bits back 0 Locked

    479 views
    2 replies
    Latest over 16 years ago
    by DHarmon
  • Not Answered

    TL16CP554APM - Rx problem 0 Locked

    380 views
    0 replies
    Started over 13 years ago
    by Ziga Kalan
  • Not Answered

    scansta111 scansta112 chips 0 Locked

    482 views
    0 replies
    Started over 13 years ago
    by Victor
<