Other Parts Discussed in Thread: SN74LVC1G34, SN74AHC1G125
Hello
Short question. I just want to confirm.
In the first page of DS "5v tolerant inputs"
at page 6/24 "Recommended operating Conditions"
max 5.5v input and Vcc.
I would like to use this device to translate 5.5v logic signal to 3.3v. From my understanding it is ok, in my design the device will have VCC=3.3v and the input at pin2 will be up to 5.5v.
Any drawbacks when input signal is 5.5v ?
Will rise/fall time be affected? If still in nS range it is not any problem in this design,
Thank you for your help!
