• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 29 subscribers
  • Views 97 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

DK-TM4C129X: TIVA C Development tool

DK-TM4C129X: DK-TM4C129X

John Boecker
Prodigy 100 points

Part Number: DK-TM4C129X

I was able to download the LM Flash Programmer utility.  Is the utility used with the USB-micro port or the JTAG to perform the FW upgrade.  After the image in the previous reply from Ti, reference is made to JTAG.  If JTAG is used, are there jumpers that need to be set so U3 is updated and not U1?

  • +1
    TI__Guru**** 159495 points

    Hi,

      LM flash programmer only supports ICDI debug probe. DK board has the on-board ICDI probe. You just need to connect the USB-micro cable to the board. You don't need to use the JTAG connector. The JTAG connector is used when you have a non-ICDI debug probe.