MSP430F67791: How to compile the source code and flash it to the EVM430-F6779 board

Hi

Please check this thread discussion https://e2e.ti.com/support/tools/code-composer-studio-group/ccs/f/code-composer-studio-forum/860781/msp430f67791-slaa577-code-not-compiling-in-ccs?tisearch=e2e-sitesearch&keymatch=slaa577#

http://www.ti.com/lit/zip/slaa577 is not CCS project.

Thanks!

Hello Xiaodong,

Thank you for the reply,

why this link ( http://www.ti.com/lit/zip/slaa577 ) is used?

where i can find the metrology formulas to know the code flow?.

and how to add my custom code into the EVM

regards.

Hi 

slaa577 is the project on IAR

 We recommend that you use our Energy Measurement Design Center and software library which does support CCS and the EVM430-F6779.

Thanks

Thanks Xiaodong,

Okay i will use EMDC for that.

as i asked before where i can find the metrology formulas?

regards.

Hi 

So far, I can't find the direct information on metrology formulas

Three-Phase Metrology With Enhanced ESD Protection and Tamper Detection Reference Design (TIDM-3PHMTR-TAMP-ESD) should be the reference.

The previous E2E thread discussion is the reference as well 

e2e.ti.com/.../324864
e2e.ti.com/.../567074
e2e.ti.com/.../618995
e2e.ti.com/.../626586

Thanks

Hello Nikhitha,

Sorry for writing here.

I have tried with EMDC and loaded generated code on the energymeter.But its not working as display is not showing anything like phase A, current or voltage etc.

Did you find answer on how to load source code back to EVM430F6779 energymeter? Did it work ?

Thank you.

Sincerely,
Abhi