MSP low-power microcontrollers

MSP low-power microcontroller forum

State TI Thinks Resolved
Locked Locked
Replies 3 replies
Answers 1 answer
Subscribers 78 subscribers
Views 163 views
Users 0 members are here

Support feedback

Options

Options

Similar topics

MSP-GANG: C# help with which functions show which device is Connected and the Program status of the Board.

Brandon Moore

Prodigy 25 points

Part Number: MSP-GANG

I'm creating a C# application that I want to check if I'm Connected to a Board on one of the 8 spots for the MSP-GANG. In the GANG Programmer UI that is provided, in the Results section it Shows Connect and Program. I'm trying to figure out which function Can I call that will relay this information. I thought it might be the MSP_GetProgressStatus but I'm not receiving any data back. I could be doing something wrong just wanted to get some help.

0 Sal Ye 4 months ago

TI__Genius 11585 points

Hi Brandon,

It is out of my ability to help you use MSP-GANG for specific usage.

I have two suggestions for it:

#1. Check the MSP-GANG user guide for detail instructions. It is included in the GANG software installation. Chapter 4 might be helpful for you.

#2 Contact yout supplier for technical support from elprotronic (GANG supplier).

B.R.

Sal

0 Sal Ye 4 months ago in reply to Sal Ye

TI__Genius 11585 points

I will keep the thread open, in case anyone have used this function before and can give you some advice.

B.R.

Sal

0 Sal Ye 4 months ago in reply to Sal Ye

TI__Genius 11585 points

Hi Brandon,

I will close the thread due to there is no update from any side. If you have any further question, you can reply here or file a new one.

Thanks!

B.R.

Sal

**Attention** This is a public forum