EVM430-FR6047: How to get the eval board LCD to work?

Eric Nutsch

Part Number: EVM430-FR6047

Tool/software:

Probably a dumb question, but everything else worked out of the box except the LCD. I adjusted the R11 resistor per the hardware guide but no change.

Jumper I need to set?
Certain button press on the 5 push buttons?
The LCD is not supported by the demo code and you have to go find that library?

1 month ago

+1 Cash Hao11 1 month ago

TI__Mastermind 30625 points

Hi,

No need to modify the hardware.

After power up the board, try double click the UP button and then double click the Middle button. Repeat this operation until you get something showed in the LCD.

Best regards,

Cash Hao

0 Eric Nutsch 1 month ago in reply to Cash Hao11

Prodigy 40 points

Awesome thanks! Twice on the top button worked on the board that I re-flashed with the Windows Installer for USS Water Demo for FR604x firmware. I couldn't get the one that is still on the shipped firmware to work, but I will just re-flash it and will be good to go. Thanks!

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

EVM430-FR6047: How to get the eval board LCD to work?