Tool/software:
hi
i am attempting to use the CCS with the EVM430-FR6047 board, shown here. note the switch is in the middle on the ezFET position
when trying load a program, i am receiving the following error in CCS
thanks,
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software:
hi
i am attempting to use the CCS with the EVM430-FR6047 board, shown here. note the switch is in the middle on the ezFET position
when trying load a program, i am receiving the following error in CCS
thanks,
Please check the jumpers at there. Especially for the 3V3, GND, RST, and TEST.
Hi Eason,
i believe there are jumpers on the proper connectors, kindly confirm
:Br. Regards,
Ephraim
I do the same setup for the jumpers on my side. I can program it well. Can you double check the power supply on MCU side with multimeter?
If the power supply is good, I think the MSP430 on the board is broken. You may need to replace a new one.
Hi Eason,
where should i check exactly.
note that using the MSP-FET430UIF, I can program.
Br.
Can you connect MSP-FET430UIF at these 4 pin and reprogram it. If it is succeed. It should have problem with the EZ-FET part.
Can you also check whether after you pulg in the USB port, D101 will light. If yes, the problem may not lies on the eZ-FET. But you can try to reporgram it with this code:
**Attention** This is a public forum